Door Controls DC-ONE V3 Руководство по началу работы и устранению неполадок - Страница 3
Просмотреть онлайн или скачать pdf Руководство по началу работы и устранению неполадок для Контроллер Door Controls DC-ONE V3. Door Controls DC-ONE V3 13 страниц. Automatic door controller
Печатать страницу
MENU ITEMS
FAULTS DETECTED
displayed here.
LEARN TORQUE
rate of speed and power. This prevents the door and components
from being damaged during setup. The door must travel with
enough speed and power to move fully open and fully closed
without slamming. The door must stop at these positions without
any rebound. The learn sequence is what sets the position
endpoints to the controller via encoder counts. Not all door are
the same and some move harder than other therefore sometimes
the torque need to be raised. Adjust this approx 5% till the door
travels correctly.
LEARN OPEN SPEED
just enough to complete the learn cycle. If door isn't traveling fast
enough, It is recommended to adjust Learn Torque first.
LEARN OPEN SPEED
just enough to complete the learn cycle. If door isn't traveling fast
enough, It is recommended to adjust Learn Torque first.
SELECT MOTOR TYPE
proper motor type that matches your application. Failure to have
the correct type selected can result damage of the door an learn
cycle may not be completed.
PHONE NUMBER
DOOR CONTROLS USA TECH SUPPORT - 800-437-3667.
Please have the following information. Controller Type, Motor
Type, Firmware version, Incoming Line Voltage, & What
accessories are installed (lock, sensor, ect)
SOFTWARE VERSION
controller
OPEN SPEED
CLOSE SPEED Door Closing Speed
OPEN CHECK SPEED
CLOSE CHECK SPEED
BOOST SPEED This function is for doors that have a heavy
drag from weather stripping. (it gives the door and extra push at
the start of the open and closed cycle.) Leave this set to default.
Faults or Fault information will be
The learn Sequence is run at a reduced
Adjust speed to allow door to travel
Adjust speed to allow door to travel
It is very important to select the
When all else fails call this number for
Current Firmware version in the
Door Opening Speed
Full Open Slow Speed Full Close
Slow Speed