astra telematics AT210 Руководство пользователя - Страница 6

Просмотреть онлайн или скачать pdf Руководство пользователя для GPS astra telematics AT210. astra telematics AT210 9 страниц. Vehicle tracking device
Также для astra telematics AT210: Руководство по установке (5 страниц), Краткое руководство по эксплуатации (4 страниц)

SIM installation

Note that the AT210 powers up when the SIM is fitted

Basic electrical connections

A permanent connection to +12V/+24V vehicle power should be provided to the AT210

using the RED and BLACK wires, via a 1A fuse. If using a wired ignition-sense, connect

this to digital input 1, again we recommend the use of a 1A fuse:

i. RED

ii. BLACK

iii. WHITE

All unused wires should be insulated to avoid undesired behaviour.

For a full table of AT210 connections please see page 8.

Power requirements

The AT210 operates from a DC Voltage between 6 and 36 Volts. We recommend that a

permanent 'live' power source is used to supply the AT210. If current drain is of

concern, please see the power-down option of the $IGNM command, which can be used

to minimise battery drain when vehicles may be stationary for long periods.

External GNSS antenna (optional)

The AT210 has an internal GNSS antenna, so an external antenna is not required in

most cases, but if the device is mounted in a location with poor sky visibility, an

external antenna can be used. If this is required, remove the cover from the GNSS

antenna connector (adjacent to the DB9) and plug in the AE004 GNSS active patch

antenna.

Notched corner here

+12 / +24V 1A FUSED

GROUND

1A FUSED

IGNITION

1A FUSED

External GNSS antenna connection