astra telematics AT210 Руководство по установке - Страница 2

Просмотреть онлайн или скачать pdf Руководство по установке для GPS astra telematics AT210. astra telematics AT210 5 страниц. Vehicle tracking device
Также для astra telematics AT210: Руководство пользователя (9 страниц), Краткое руководство по эксплуатации (4 страниц)

3. Fit the DB9 Cable

a. Connect the sealed DB9 cable and tighten the jack-screws finger tight, until the seal is

compressed against the enclosure end panel

4. Hook up the electrical connections

a. Connect the RED and BLACK wires to a PERMANENT +12V/+24V vehicle power source

via a 3A fuse. Connect the ignition sense input (Digital 1) to an ignition switched

12/24V signal (i.e. something that only goes live when the vehicle ignition is ON) via a

3A fuse

i. RED

ii. BLACK

iii. WHITE

b. We recommend that all connections should be soldered to ensure reliable

terminations. Crimps and IDC type terminations can be unreliable if used with the

wrong tooling and/or wires sizes.

c. All unused wires should be insulated to avoid undesired behaviour.

5. Connect the iButton Probe (if required)

Fit the IB001 iButton probe in the desired position on the vehicle dashboard (requires

drilling a hole) and then connect to the matching connector on the CB203 standard

cable (accessories are not supported using the basic 3-way cable).

b. Please refer to the Driver ID Application Note for more information regarding the use

and configuration of iButton options and recommended iButton accessories.

6. Fit the external GNSS antenna (if required)

a. The AT210 has an internal GNSS antenna, so an external antenna is not required in

most cases, but if the device is mounted in a location with poor GNSS visibility, an

external antenna can be used. If this is required, remove the cover from the GNSS

antenna connector (adjacent to the DB9) and plug in the AE005 GNSS active patch

antenna.

b. To maintain the IP67 sealing, it is necessary to seal the GNSS antenna connector (after

it has been connected) with silicone sealant or similar.

c. If the external GNSS antenna is not used, please leave the sealing cover in place.

+12 / +24V

1A FUSED

GROUND

1A FUSED

IGNITION

1A FUSED