ASTRO TOOL Corp. 620175 Инструкции - Страница 2
Просмотреть онлайн или скачать pdf Инструкции для Электроинструмент ASTRO TOOL Corp. 620175. ASTRO TOOL Corp. 620175 2 страницы. Connector assembly tooling cycle controlled c-frame style crimp tool
Печатать страницуShank
Press
Figure # 3
NOTE: To determine which Die is Stationary
or Movable; Die Post must align with Die
Nest when Die Half is engaged with key.
4. Cycle the tool to insure that the dies are
seated properly. See figure # 4.
Figure # 4
d. Crimping Operation
1. The tool must be in the fully open position.
Insert the prepared connector through the tool
opening and place in the appropriate cavity.
For RF connector fittings, use the die face as a
locational stop. For shield terminations, locate
the crimp by eye.
2. Squeeze the handles together until the
positive stop is reached. The tool will release
and return to the fully open position.
3. Remove the crimped termination.
e. Die Removal
1. The tool must be in the fully open position.
2. To remove the Stationary Die, locate the
Die removal Tool (P/N DRT5). Place the tool
against the button at the end of the tool.
Gently tap Die Removal Tool. The die will
release from the retainer and slide out of the
die nest. See Figure # 5.
ASTRO TOOL CORP. MANUFACTURERS OF INSTALLING, REMOVAL, CRIMP TOOLS
21615 S.W. T-V HWY. • BEAVERTON OREGON 97003 • 503-642-9853 • FAX 503-591-7766
AND CONNECTOR SERVICE KITS
2
DRT5
Button
Figure #5
NOTE: Always remove the Stationary Die
First.
3. To remove the Movable Die, hold the tool
in the fully closed position. Hook the
Removal Tool around the Movable Die nest as
shown in figure # 6. Move the handles to the
fully open position and the die will release
from the retainer and slide out of the die nest.
Figure # 6
TOOL SERVICE
Astro Tool's 620175 Crimp Tool is designed for
long, reliable service. If the tool becomes
inoperative or does not gage properly, it is suggested
that you contact our Customer Service Department
for a Return Goods Authorization number and return
the tool to our factory.
Upon receipt of the tool, Astro will inspect and
overhaul each tool to put the tool back into
acceptable and efficient operating condition. Worn
parts will be replaced or repaired. Please note that
Astro's Quality Control system is traceable to The
National Institute of Standards and Technology
(N.I.S.T.).
Service charges for tools not under warranty will
be advised upon request.
Parts that Astro deems to have been damaged due
to neglect, misuse or accident; and parts that have
been altered or repaired by persons other than Astro
Tool Corp. employees will be replaced subject to
additional charge for such parts.
5-21-15 TI175-95-1