ASTRO TOOL Corp. 620175 Talimatlar - Sayfa 2

Elektrikli Alet ASTRO TOOL Corp. 620175 için çevrimiçi göz atın veya pdf Talimatlar indirin. ASTRO TOOL Corp. 620175 2 sayfaları. Connector assembly tooling cycle controlled c-frame style crimp tool

Sayfayı Yazdır

Shank

Press

Figure # 3

NOTE: To determine which Die is Stationary

or Movable; Die Post must align with Die

Nest when Die Half is engaged with key.

4. Cycle the tool to insure that the dies are

seated properly. See figure # 4.

Figure # 4

d. Crimping Operation

1. The tool must be in the fully open position.

Insert the prepared connector through the tool

opening and place in the appropriate cavity.

For RF connector fittings, use the die face as a

locational stop. For shield terminations, locate

the crimp by eye.

2. Squeeze the handles together until the

positive stop is reached. The tool will release

and return to the fully open position.

3. Remove the crimped termination.

e. Die Removal

1. The tool must be in the fully open position.

2. To remove the Stationary Die, locate the

Die removal Tool (P/N DRT5). Place the tool

against the button at the end of the tool.

Gently tap Die Removal Tool. The die will

release from the retainer and slide out of the

die nest. See Figure # 5.

ASTRO TOOL CORP. MANUFACTURERS OF INSTALLING, REMOVAL, CRIMP TOOLS

21615 S.W. T-V HWY. • BEAVERTON OREGON 97003 • 503-642-9853 • FAX 503-591-7766

AND CONNECTOR SERVICE KITS

DRT5

Button

Figure #5

NOTE: Always remove the Stationary Die

First.

3. To remove the Movable Die, hold the tool

in the fully closed position. Hook the

Removal Tool around the Movable Die nest as

shown in figure # 6. Move the handles to the

fully open position and the die will release

from the retainer and slide out of the die nest.

Figure # 6

TOOL SERVICE

Astro Tool's 620175 Crimp Tool is designed for

long, reliable service. If the tool becomes

inoperative or does not gage properly, it is suggested

that you contact our Customer Service Department

for a Return Goods Authorization number and return

the tool to our factory.

Upon receipt of the tool, Astro will inspect and

overhaul each tool to put the tool back into

acceptable and efficient operating condition. Worn

parts will be replaced or repaired. Please note that

Astro's Quality Control system is traceable to The

National Institute of Standards and Technology

(N.I.S.T.).

Service charges for tools not under warranty will

be advised upon request.

Parts that Astro deems to have been damaged due

to neglect, misuse or accident; and parts that have

been altered or repaired by persons other than Astro

Tool Corp. employees will be replaced subject to

additional charge for such parts.

5-21-15 TI175-95-1