Cola TERMO REGINA 4 Руководство по установке, использованию и обслуживанию - Страница 10

Просмотреть онлайн или скачать pdf Руководство по установке, использованию и обслуживанию для Плита Cola TERMO REGINA 4. Cola TERMO REGINA 4 15 страниц.

Before connecting a heating stove to an existing chimney, in addition to complying with that described
above, make sure there are no openings or cracks where air could enter and cause a temperature
decrease affecting the draught.
Also make sure there are no hindrances caused by foreign bodies or a build-up of soot.
The first connection
section
leaving
the
stove
should
be
vertical, whereas the
flue connection to the
chimney (which goes
to the chimney cap)
must only enter by a
few cm, so as not to
reduce
the
cross
section of the flue.
If
the
flue
is
not
perpendicular to
the
chimney
it
is
advisable to make the
connection
with
special steel fittings
that allow a maximum slope of 45° .
If the walls and ceiling are made of flammable materials, the parts in contact with the flue must be
suitably insulated. All connection joints must be carefully sealed, in particular where the connection
enters the flue.
If there are several heating stoves in the same home, each must have its own flue. It is inadvisable to
make openings in the flue for other appliances, since the draught could be negatively affected.
According to Standard UNI 7429, the chimney cap must meet several requirements; above all, it must
have a useful outlet cross section at least double that of the flue. It is also advisable to install an
"antiwind" cap that guarantees fume exhaust even in the presence of strong horizontal winds.
Fig. 4 Chimney caps
3 – STOVE USE
3.1 Introduction
Never leave children unsupervised in the vicinity of the stove; the risk of burns caused by the hot parts
is very high.
Make sure to carefully observe the following rules:
- never use the stove with the door open;
- do not store firelighters or easily flammable materials near the stove
Fig. 3 Stove-chimney connection
10
Termo Regina 4