Cansec H1000 Руководство по установке - Страница 13

Просмотреть онлайн или скачать pdf Руководство по установке для Контроллер Cansec H1000. Cansec H1000 20 страниц. Elevator control

SLAVE PANEL COMMUNICATION LEDS

 Slave EX100 Communication LEDs

The slave EX100 RS485 communications are indicated by RX485 - LED1 and TX485 -

LED2. The green TX RS485 LED will only toggle when the address of the Slave H1000

is sent from the Master H1000 control panel. When the Slave H1000 receives this poll

it will send the response to the Master H1000 panel. See previous section which

describes the "Master H1000 EX100 Communications"

RX485 LED

 Slave H1000 RD8, RD7, RD6 LEDs

RLED8

RLED7

An additional H1000 Slave setup verification is implemented in this firmware. Three

LEDs are used to indicate what address the H1000 Slave panel is set to. These LEDs

near the reader ports RD8, RD7 and RD6 are labeled as RLED8, RLED7 and RLED6

respectively. Each time the Master control panel communicates to the H1000 Slave one

of these LEDs will toggle. If the Slaves have been correctly configured, the correct LED

that will toggle is indicated below:

Slave 1 = RLED8

Slave 2 = RLED7

Slave 3 = RLED6

TX485 LED

RLED6

H1000 Elevator Control

Installation Guide

Page 13 of 20

October 2015 • Rev. 1.7