Dafra DNP3212-2 Руководство по эксплуатации - Страница 2

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Заклепочные инструменты Dafra DNP3212-2. Dafra DNP3212-2 9 страниц. Rivnut tool

DNP3212-2 RIVNUT TOOL CAPACITY

Blind rivnuts M3 – M4 – M5 – M6 – M8 – M10 – M12 in all materials and styles.

TOOL SPECIFICATIONS

Air supply pressure:

Output traction power:

Stroke:

Net weight:

Please refer to the TOOL EXPLOSIVE ILLUSTRATION and the PARTS LIST in this manual in order to

have a good understanding of the tool parts described. The descriptions of the tool parts appear in this

manual are in italics.

1) This pneumatic powered tool should be worked with compressed air supply. It is recommended to

use the air hose with diameter bigger than 8 mm;

2) To check the compressed air pressure within the specified range between 0,5Mpa and 0,7Mpa, and

to connect the air hose adaptor onto the tool air adaptor. The air adaptor has its different versions in

different countries and areas, normally the tools are equipped with the correct version as default, in

case the air adaptor does not apply in your air supply hose adaptor, contact the tool distributor(s);

3) To change and use correct cap screw and anvil according to the size of the rivnut to be set. This tool

is equipped with cap screws and anvils from M3 up to M12 in the tool kit. For convenience, 7 identical

locknuts provided in the tool kit for each size of the cap screw and anvil in pairs;

a) To remove the anvil from the tool and the locknut:

b) To remove the retaining ring and nose sleeve:

c) To use a spanner to loosen adaptor sleeve from spring house, take out cap screw, drive bar

washer, adaptor sleeve, drive bar and spring:

0.5Mpa ~ 0.7Mpa

21,000N ~ 29,400N

1mm ~ 7mm adjustable

1.91kgs