Amphenol Telect nrgCONTROL-BT Руководство по установке - Страница 11

Просмотреть онлайн или скачать pdf Руководство по установке для Контроллер Amphenol Telect nrgCONTROL-BT. Amphenol Telect nrgCONTROL-BT 11 страниц.

FCC Class A Notice

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference.

2. This device must accept any interference received, including interference that may cause undesired

operation.

NOTE: This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part

15 of the FCC Rules. These limits are designed to provide a reasonable protection against harmful interference when the

equipment is operated in a commercial environment. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instruction manual, may cause harmful interference to radio

communications. Operation of this equipment in a residential area is likely to cause harmful interference in which case the

user will be required to correct the interference at his own expense.

Modification

Any modification made to this device that are not approved by Amphenol Telect may void the authority granted to the user

by the FCC to operate this equipment.

ICES-003 Class A Notice – Avis NMB-003, Classe A

This Class A digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe A est conforme á la norme NMB-003 du Canada.

WARNING! The intra-building port of the equipment is suitable for connection to intra-building or unexposed

wiring or cabling only. The intra-building port of the equipment must not be metallically connected to interfaces

that connect the OSP (outside plant) or its wiring. These interfaces are designed for use as intra-building

interfaces only (Type 2 or Type 4 ports as described in GR-1089) and require isolation from the exposed OSP

cabling. The addition of Primary Protectors is not sufficient protection in order to connect these interfaces

metallically to OSP wiring.

ELECTROSTATIC DISCHARGE (ESD) PRECAUTIONS

ELECTROSTATIC DISCHARGE (ESD) PRECAUTIONS! When handling any electronic component or assembly you

must observe the following antistatic precautions to prevent damage. Always disconnect power from the server

and wear a ground wrist strap when working around the nrgCONTROL-BT. Always wear a grounded wrist strap

when handling printed circuit boards. Treat all assemblies, components and interface connections as static-

sensitive.

nrgCONTROL-BT

Amphenol Telect

1-509-926-6000 — telect.com