Amphenol Telect nrgCONTROL-BT Руководство по установке - Страница 9

Просмотреть онлайн или скачать pdf Руководство по установке для Контроллер Amphenol Telect nrgCONTROL-BT. Amphenol Telect nrgCONTROL-BT 11 страниц.

2.6 nrgCONTROL Connectivity

The nrgCONTROL panel utilizes the LAN port located on the front of the unit to connect the controller to the data storage

location.

The controller can be operated in the following modes simultaneously:

1. Local Only Mode

•

The controller will collect data from all panel sensors that are connected to it over nrgNET interface

•

No SNMP traps or data is sent for monitoring

•

The instantaneous sensor data can be viewed from the front of the controller's LCD screen for all attached

monitoring panels

2. SNMP Mode

•

The LAN port must be connected and configured to operate on the same subnet as the customer defined

SNMP/NMS server address

•

The nrgSMART MIB table is available for download at the following URL:

www.telect.com/NewProductDetail/nrgsmart-controller

•

SNMP traps can be set-up for current threshold crossings, breaker trips or blown fuses, voltage threshold

crossings and temperature threshold crossings

•

Sensor data and configuration data can be polled by issuing commands from the NMS

•

The NMS will have to manage and store all collected data

The nrgCONTROL-BT uses a static IP address of 192.168.1.1 with a subnet mask of 255.255.255.0. Set up your PC or

server to an address on the same subnet as the nrgCONTROL-BT. To do this, follow the steps below:

1. Connect a CAT5 cable to the front panel LAN connector of the nrgCONTROL-BT panel.

2. Go into Network Settings from either the Control Panel or the Network icon in the bottom right corner of the task bar

on your PC.

NOTE: There will be different paths to get to these settings based on your operating system.

3. Double-click Ethernet or LAN connection.

4. Select Internal Protocol Version 4 (TCP/IPv4).

5. Change your settings from Obtain an IP Address Automatically to Use the Following IP Address in the subnet range of

192.168.1.2 – 192.168.1.254 subnet mask of 255.255.255.0; no gateway or DNS needed.

6. Hit OK on the next two screens to complete the change.

7. Open the nrgCONTROL-BT via a browser by its IP address of 192.168.1.1.

NOTE: Chrome is recommended browser. Other supported browsers include Firefox.

8. The Configuration Wizard will be displayed.

For connecting and configuring your nrgSMART panels, please refer to nrgSMART Configuration Guide.

nrgCONTROL-BT

RJ-45 LAN port

Amphenol Telect

1-509-926-6000 — telect.com