AMS AS5600 Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Аксессуары AMS AS5600. AMS AS5600 12 страниц. 12-bit programmable contactless potentiometer
Также для AMS AS5600: Руководство (14 страниц), Руководство пользователя (13 страниц), Руководство по эксплуатации (10 страниц)

AS5600-SO_RD_ST

Operation Manual

The magnet is already aligned to get AGC values in the middle of the AGC range.

Note: If the magnetic field seen by the AS5600 would be below 8mT, the output would be switched

off and permanent angle programming would not be possible.

2.4 Electrical Setup

The reference module is many used in following configurations in 5V or in 3.3V mode.:

In this mode, the power supply and the output pin of the reference module are connected. To

program a custom angular output range, short R4 using a 0R resistor to enable the programming

option B. Follow the step-by-step instructions in the AS5600 datasheet to program the device.

Figure 3:

Using the board in 3-Wire Mode

µC

Analog or PWM IN

2.4.2 I

Using the I2C Interface, all functions of the AS5600 can be configured and permanently

programmed. Additionally the output and a raw angle (unmodified value) can be read from the

output registers.

Figure 4:

Using the reference module in I2C Mode

µC

www.ams.com

SDA

SCL

Revision 1.1 / 30.06.2014

page 6/11