Dr. Clark VariZapper 2.0 Руководство - Страница 9

Просмотреть онлайн или скачать pdf Руководство для Средства личной гигиены Dr. Clark VariZapper 2.0. Dr. Clark VariZapper 2.0 15 страниц.

Печатать страницу

1. Using Program Drivers/Microsd Cards

The VariGamma 2.0

4.1.5 Main Menu

After the welcome panel, the Main Menu panel will be displayed. Rotate the Turnwheel to select one of

the functions displayed and press the wheel to select a function.

You can choose from (Fig. 14):

• Run the last program that was used in the previous session;

• Select a program in the list of stored programs in the library (Normal Zapping: 7min zapping - 20min

pause - 7min zapping - 20min pause - 7min Zapping/32Khz/square wave/positive offset, Continuous

Zapping: 60min zapping/32Khz/square wave/positive offset, Zappicator: 10min zapping/1Khz/square

wave/positive offset)

• Settings (Language, Display and Sound)

Fig. 14

4.1.6 Running programs and functional options

4.1.6.1 Program phases and steps

A program has a maximum of 30 steps. A step consists of an active working phase followed by a

passive pause phase of a minimum of 5 seconds without an output signal before moving to the next

step. Each step is defined by parameters such as Frequency, Wave form (SINE or SQUARE) and

Voltage, which are displayed during the active phase.

If a „Wobble" function is set, there is an upper and a lower frequency, between which the generated

frequency oscillates. The continuously changing frequency values are then constantly adjusted on the

display while the program is running.

4.1.6.2 Pausing & stopping program or skipping steps

While the program is running, there are three icons on the bottom of the display:

•

to pause the program

•

to go back to Main Menu

•

to skip a step

PAUSE: You can pause the program while it is running by selecting

stop moving.

RESUME: You may start the program again by selecting

STOP: To stop the program press

button to choose:

• YES to stop program and go back to Main Menu

• NO to continue with the program running

SKIP STEP: Use the Turnwheel button to choose

appear (Fig.17). Use the Turnwheel button to choose YES or NO:

• select YES to skip the step

• select NO to continue with the program running

Fig. 15

(Fig. 16).

. A confirmation panel will appear (Fig. 17). Push the Turnwheel

to skip the running step. A confirmation panel will

Fig. 16

(Fig. 15). The wave graphic will

Fig. 17