Bosch FAP-OC 500Series Руководство по установке - Страница 5

Просмотреть онлайн или скачать pdf Руководство по установке для Посудомоечная машина Bosch FAP-OC 500Series. Bosch FAP-OC 500Series 28 страниц. Built-in wall ovens
Также для Bosch FAP-OC 500Series: Руководство по установке (21 страниц), Руководство по эксплуатации (40 страниц), Руководство по установке (6 страниц), Информация о продукте (40 страниц), Руководство по установке (28 страниц), Руководство пользователя (48 страниц), Руководство пользователя (48 страниц), Руководство по установке (28 страниц), Руководство по эксплуатации и уходу (44 страниц), Руководство по установке (32 страниц), Руководство по эксплуатации и уходу / инструкция по установке (40 страниц), Краткое справочное руководство (4 страниц), Руководство по эксплуатации и уходу (27 страниц), Руководство по установке (24 страниц), Руководство по установке (32 страниц), Руководство по эксплуатации и уходу (24 страниц), Руководство по эксплуатации (41 страниц), Руководство по эксплуатации и уходу (21 страниц), Руководство по установке (32 страниц), Руководство по эксплуатации (36 страниц), Руководство по установке (32 страниц), Краткое руководство по эксплуатации и технике безопасности (13 страниц)

Bosch FAP-OC 500Series Руководство по установке

Before you begin

Tools and Parts Needed

Philips head screwdriver
1/8" drill bit and drill
Measuring tape

Parts Included

Built-in oven

Power Requirements

The outlet must be properly grounded in accordance with
all applicable codes.
The electrical outlet for the appliance must either be
located in the shaded area A or outside of the area
where the appliance is installed.
Secure any unsecured units to the wall using a
standard bracket B.

Removing Packaging

NOTICE: To prevent damage to your floor keep the unit
in its packaging base until ready to be placed in the
cabinet opening. Do not slide the unit across the flooring.
Cut straps on outside of box.
1.
Remove cardboard box.
2.
Remove all top and side cardboard and Styrofoam
3.
braces.
Place oven in front of cabinets where it is to be
4.
installed.
B e f o r e y o u b e g i n

Preparing the units

This unit must be installed according to all installation
instructions to ensure its safe operation.
Check the appliance for damage after unpacking it. Do
not connect the appliance if it has been damaged in
transit.
Proceed in accordance with the installation sheets for
installing accessories.
Before starting up the appliance, remove any
packaging material and adhesive film from the
cooking compartment and the door.
The cabinet into which the appliance is built in must be
heat-resistant up to 195° F (90 °C), and adjacent
cabinet fronts up to 160° F (70 °C).
Do not install the appliance behind a decorative panel.
There is a risk of overheating.
Any cut-outs that need to be made in the units should
be made before the appliance is installed. Remove
any shavings, as they may prevent the electrical
components from working properly.
Wear protective gloves to prevent cuts. Parts that are
accessible during installation may have sharp edges.
Secure any unsecured units to the wall using a
standard bracket.
The dimensions in the figures are in inches (mm).
5