Electrolux Clarus Vibe WH6-14LAG Руководство по установке - Страница 15

Просмотреть онлайн или скачать pdf Руководство по установке для Стиральная машина Electrolux Clarus Vibe WH6-14LAG. Electrolux Clarus Vibe WH6-14LAG 32 страницы. Washer extractor

Печатать страницу

5 Water connection

All water intake connections to the machine should be fitted with manual shut-off valves and filters, to facilitate instal-

lation and servicing.

Water pipes and hoses should be flushed clean before installation.

The machine shall be connected with new water hoses. Re-used water hoses must not be used.

Hoses are to be of an approved type and grade and comply with IEC 61770.

After installation hoses must hang in gentle arcs.

All connectors present on the machine must be connected. The table shows the possible connection options, which

will depend on the water types to be connected to the machine. Information is also available on the panel above the

connections.

Remove the three plastic covers (A).

Note!

For unheated machines with Lagoon Advanced Care programs, the programs requires pre heating (25℃) for

the cold water valves.

Note!

The inlet temperature for cold water must not be higher than 25℃. If so, a water cooling system must be

installed.

Installation manual

Water type

• Cold and hot

Water connection

1. Cold

2. Hot

3. Cold (for detergent dispenser) / Hot

fig.7811B