Formech DT-508 Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Вакуумные формовочные машины Formech DT-508. Formech DT-508 5 страниц. Vacuum forming machine
Печатать страницуUsing Without Reducing Window
1. First you must place the part you want to vacuum
form to in the bed by pulling the lever on the side of
the machine towards you until it locks into place
2. Now make sure that clamp frame is raised and place
your material onto the machine covering the open
square completely
3. Lower the clamp frame and close the locks on the
handles closest to you to secure the material to the
vacuum former
4. Pull the heater over the material by grabbing the
blue handle and pulling it towards you
5. Wait for the material to heat up to the right
temperature
a. Watch the material, at first it will warp in
different areas then when it is finally ready to
be formed it will uniformly droop at the center
by about an inch and a half
6. Once the material is ready push the heater top to
the back of the machine and you are ready to
vacuum the material