Formula Activa Технический информационный листок - Страница 4

Просмотреть онлайн или скачать pdf Технический информационный листок для Аксессуары для велосипедов Formula Activa. Formula Activa 6 страниц.

Печатать страницу

11d:

Using a 4mm spanner, unscrew the screw (8) as

shown in the figure.

11e

11f

11g:

Utilising the tool shown in the figure, unscrew the

internal ring (12) in an anti-clockwise direction and

remove it.

11h

11i:

Separate the rotor (15) from the counter-rotor (13)

and clean the components using a brush dipped in alco-

hol.

ATTENTION: Be careful to not drop and lose

the internal ball bearings (14) of the rotor

unit.

11l

Reinsert the internal pad (19) and fix it with the metal

tongue (20) and the appropriate screw (21).

11m:

Insert a 2.5mm spacer between the two pads.

Reinsert the rotor unit and fix it with the internal ring (12)

utilising the appropriate tool.

11n

11d

11e:

ATTENTION: Never disassemble the pincer

lever using tools.

Remove the lever unit.

11f:

11g

11h:

Utilising pincers, slide out the rotor unit

Remove the internal pad (19) from the pincer body and

clean it using a brush dipped in alcohol.

To clean the rotor unit it is necessary to remove the exter-

nal pad (18).

11i

11l:

Before reassembling the rotor unit, smear a small

quantity of grease in the seats of the ball bearings.

ATTENTION: Be careful to reassemble the

rotor unit so that the teeth of the counter-

rotor coincide with an angle of the hexagon of the

rotor.

11m

11n:

After having substituted the rubber (11), reassem-

ble the lever unit taking care to insert the lever pin into

the hole of the counter-rotor.

Rotate the lever and position it as shown in the figure

keeping it pushed downwards.

Grease the pins of the adaptor (3) and reassemble the

remaining components proceeding in the reverse order

of removal.

- 4 -

SUBSTITUTION OF THE BRAKE PADS

N.B.: The numbers in parentheses indicate the reference

of the parts in the exploded view.

12:

Activa version

Remove the cable from the lever of the braking system

without unscrewing the cable grip.

Remove the pincer unit by slackening the fixing screws

13:

Removal of the internal pad

Unscrew the screw U (21) utilising a 2.5mm hexagonal

spanner.

Straighten the safety tongue V (20) and remove the used

pads Z.

ATTENTION: Be careful when using the

screwdriver: the dimensions of the parts are

small and therefore this operation could cause

injuries to the hand. Wear protective gloves.

14:

External pad removal

Bring the pommel Y (22) into the position where it is

touching the circlip.

Extract the plastic protection K.

Insert a small-bladed screwdriver (see figure) between

the pincer body J (24) and the support surface of the pad

Apply a light pressure in the direction indicated by the

arrow and remove the worn out external pad.

Rotate the external pad adjustment pommel X (23) in an

anti-clockwise direction until it stops.