CommScope FACT Руководство по установке
Просмотреть онлайн или скачать pdf Руководство по установке для Промышленное оборудование CommScope FACT. CommScope FACT 9 страниц. Fanout fixation kit
Также для CommScope FACT: Инструкция по установке (8 страниц), Инструкция по установке (12 страниц), Инструкция по установке (8 страниц)
Печатать страницу
TC-40112-IP-EN
Rev A, March 2018
www.commscope.com
FACT CABLE TERMINATION UNIT (FACT-ACCCTULLT)
Contents
1.
General product information ................................................ 1
2.
Warnings and caution ............................................................ 1
3.
Product image......................................................................... 1
4.
Kit content ............................................................................... 2
5.
Cable preparation ................................................................... 2
5.1.
General cable preparation ....................................................................... 2
5.2.
Cable preparation without central strength member........................ 3
5.3.
Cable preparation with central strength member .............................. 3
5.4.
Loose tube Ø < 2,5 mm handling.......................................................... 4
5.5.
1x Flex tube Ø 12 mm ............................................................................... 4
1.
General product information
•
The loose tube cable termination unit is designed to accomodate 1x fiber cable with an outer cable diameter be-
tween Ø 8.5 mm - Ø 15 mm or 1x flex tube Ø 12 mm.
•
The cable needs to be flexible enough to allow a bend radius less than 75 mm for IFC cable strength members
with a diameter less than Ø 2.5 mm.
•
The kit contains all parts to install 1 piece of fiber cable / flex tube on 1 ,2 or 3 FACT elements.
2.
Warnings and caution
•
Fiber optic cables may be damaged if bent or curved to a radius that is less than the recommended minimum
bend radius. Always observe the recommended bend radius limit when installing fiber optic cables and patch
cords.
•
Exposure to laser radiation can seriously damage the retina of the eye. Do not look into the ends of any optical
fiber. Do not assume the laser power is turned off or that the fiber is disconnected at the other end.
•
Pay attention to the routing of the patch cords. These should move/hang freely, where they leave the bend control.
If you see that there is tension occuring on the patch cords, please reroute these.
860642215
Rev. A
Installation Instructions
5.6.
6.
6.1.
Termination................................................................................................... 5
6.2.
Inside routing and termination................................................................ 6
7.
element) ................................................................................... 7
7.1.
Termination................................................................................................... 7
7.2.
Inside routing and termination................................................................ 7
8.
Trademarks...............................................................................9
9.
Contact Information................................................................9
© 2018 CommScope, Inc. All Rights Reserved
Page 1 of 9