Carmanah SPEEDCHECK Руководство по замене - Страница 9
Просмотреть онлайн или скачать pdf Руководство по замене для Контроллер Carmanah SPEEDCHECK. Carmanah SPEEDCHECK 10 страниц. For the solar-powered speedcheck-15/18 radar speed signs
Также для Carmanah SPEEDCHECK: Руководство по замене (11 страниц), Руководство по замене (10 страниц)
Печатать страницу4.2
SPEEDCHECK-18 Capacitor Removal
1. Remove the four screws securing the back panel on the rear of the radar sign, locate the capacitor, and
open the fuse holder.
2. Cut the two positive and two negative wires going into the capacitor, just before the heat shrink.
3. Cut the cable tie (or remove the nyloc nut on legacy systems) and fully remove the capacitor from the
system.
4. Butt splice the two positive wires together and then the two negatives together, using heat shrinkable butt
splices. It is advised to also put heat shrink over the butt splice for added protection.
a. Wago splicing connectors are also an acceptable alternative to butt splicing.
5. Close the fuse holder on the back panel of the SPEEDCHECK-18.
6. Reassemble system.
Capacitor
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
Cut wires here and splice the two
Cut cable tie and
positive (red) and negative (black)
remove capacitor
wires together respectively
SOLAR CHARGE CONTROLLER
REPLACEMENT GUIDE
|
carmanah.com
9