Anderson FFAH21 Руководство по эксплуатации - Страница 3
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Горелка Anderson FFAH21. Anderson FFAH21 8 страниц.
Также для Anderson FFAH21: Руководство по эксплуатации (10 страниц)
Печатать страницуAnderson Thermal Solutions – FFA12 Burner Operation Manual
This manual has been written for those who are already familiar with all aspects of
nozzle mix burner and its add-on components. Main contents of the manual including
safety rules, burner installation, commissioning, operation parameters, maintenance
and troubleshooting, spare parts, etc.
1. Disclaimer Notice
Anderson Thermal Solutions (Suzhou) Co., Ltd. reserves the right to change the
construction and/or configuration of our product at any time without informing
customers.
If the product or its individual modules are used for purposes other than the
designated purpose, their effectiveness and suitability must be confirmed.
Anderson warrants that the product itself will not infringe any patents. Every effort has
been made to make this manual as accurate and complete as possible. If you find
errors or omissions, please contact us so we can correct them.
2. Liability and Warranty
Due to negligence, breach of warranty or other reasons, Anderson's liability for its
products is limited to the provision of such replacement parts and will not be liable for
any other injury, loss or expense, whether direct or indirect, including but not limited
to Loss of or damage to the use of materials that sell, install, use, fail to use or repair
or replace Anderson related products.
The warranty is void if: any operation explicitly prohibited in this manual, any
adjustment or assembly process not recommended or authorized.
3. Safety instructions
Only those who were trained and qualified person can follow the manual to operate
or adjust the combustion system. The fire was prohibited within a radius of 5 meters
of the combustion system. Flame, non–covered light sources or heat sources shall not
be brought to the combustion area unless it is related to the process. Welding in
combustion control area shall be approved to ensure the safety in the area and also
preventive measures should be taken into consideration.
Before starting, the operator must confirm whether the burner and gas pipeline are in
normal working condition, and there is no flammable substance around the burner.
The burner must be operated with fuel and oxygen or air. The ignition and operation
of the burner must be performed at the specified position. The burner has been
correctly and safely installed before ignition. The ignition of the burner needs to be
performed after the combustion chamber is purged. If it is ignited at a low temperature,
it needs to be replaced with 5 times the volume of the combustion chamber to avoid
explosion.
However, it is not necessary to purge when the temperature is higher than 750°C. Air
Anderson Thermal Soluions（Suzhou）Co., Ltd
2