Anderson FFAH21 Manuel d'utilisation - Page 3

Parcourez en ligne ou téléchargez le pdf Manuel d'utilisation pour {nom_de_la_catégorie} Anderson FFAH21. Anderson FFAH21 8 pages.
Également pour Anderson FFAH21 : Manuel d'utilisation (10 pages)

Imprimer la page

Anderson Thermal Solutions – FFA12 Burner Operation Manual

This manual has been written for those who are already familiar with all aspects of

nozzle mix burner and its add-on components. Main contents of the manual including

safety rules, burner installation, commissioning, operation parameters, maintenance

and troubleshooting, spare parts, etc.

1. Disclaimer Notice

Anderson Thermal Solutions (Suzhou) Co., Ltd. reserves the right to change the

construction and/or configuration of our product at any time without informing

customers.

If the product or its individual modules are used for purposes other than the

designated purpose, their effectiveness and suitability must be confirmed.

Anderson warrants that the product itself will not infringe any patents. Every effort has

been made to make this manual as accurate and complete as possible. If you find

errors or omissions, please contact us so we can correct them.

2. Liability and Warranty

Due to negligence, breach of warranty or other reasons, Anderson's liability for its

products is limited to the provision of such replacement parts and will not be liable for

any other injury, loss or expense, whether direct or indirect, including but not limited

to Loss of or damage to the use of materials that sell, install, use, fail to use or repair

or replace Anderson related products.

The warranty is void if: any operation explicitly prohibited in this manual, any

adjustment or assembly process not recommended or authorized.

3. Safety instructions

Only those who were trained and qualified person can follow the manual to operate

or adjust the combustion system. The fire was prohibited within a radius of 5 meters

of the combustion system. Flame, non–covered light sources or heat sources shall not

be brought to the combustion area unless it is related to the process. Welding in

combustion control area shall be approved to ensure the safety in the area and also

preventive measures should be taken into consideration.

Before starting, the operator must confirm whether the burner and gas pipeline are in

normal working condition, and there is no flammable substance around the burner.

The burner must be operated with fuel and oxygen or air. The ignition and operation

of the burner must be performed at the specified position. The burner has been

correctly and safely installed before ignition. The ignition of the burner needs to be

performed after the combustion chamber is purged. If it is ignited at a low temperature,

it needs to be replaced with 5 times the volume of the combustion chamber to avoid

explosion.

However, it is not necessary to purge when the temperature is higher than 750°C. Air

Anderson Thermal Soluions（Suzhou）Co., Ltd