DREAMS Knightsbridge Инструкции по сборке - Страница 3
Просмотреть онлайн или скачать pdf Инструкции по сборке для Внутренняя отделка DREAMS Knightsbridge. DREAMS Knightsbridge 4 страницы. Tv bed
Печатать страницуStage 2 Fitting the centre support
Bolt the two adjustable legs onto the central support bar using fixings
provided and drop the assembled unit into the support in the head and
foot of the bed frame. Ensure that the central rail sits square and the
three supporting legs sit vertically. The three adjustable feet should sit
5mm to 10mm away from the floor. DO NOT ADJUST THE FEET TO BE IN
CONTACT WITH THE FLOOR.
Stage 4 Electrical connections
1. Connect the red phono plug (lift
motor connection) from the
footboard to the red phono socket
on the control box. (connection A)
2. Connect the two black phono
plugs (lift buttons) from the two
side rails to the two black phono
sockets on the control box.
(connections B)
3. Connect the TV power lead
supplied in pack 4 between the
transformer and power socket on
the control box (marked mains
output to TV). (connections C & F)
4. Connect the 3m power lead to
the power socket on the control
box and connect to mains power
source. When power is connected
F
5mm - 10mm
Floor
the control box will emit a beep.
(connection D)
5. The three HDMI cables from the
footboard can be routed to sit in
the DVD compartment ready for
connection to DVD players, games
consoles etc. (connection E)
6. The aerial lead coming from the
footboard should be connected to
the aerial source. Please note the
bed is supplied with a male
antennae connection. For best
signal quality this should be
plugged directly into a female
aerial socket. Use of adaptors will
degrade the quality of the signal.
7. Test the lift function on both side
rail operate buttons.
D
C
B
A
E
Stage 3 Fitting the equipment tray
Partially screw the two screws into the fixing holes at either end of the
equipment tray. Drop the tray into position on the side rail and tighten all
the screws at ends of side rails and on equipment tray with the allen key
provided.
Stage 5 Fitting the wooden slats
Assemble each pair
of wooden slats with
the two plastic end
caps and one centre
cap. Push firmly
down on each cap to
ensure they are
snapped into
position in the rails.