DREAMS Knightsbridge Інструкція з монтажу - Сторінка 3

Переглянути онлайн або завантажити pdf Інструкція з монтажу для Внутрішнє оздоблення приміщень DREAMS Knightsbridge. DREAMS Knightsbridge 4 сторінки. Tv bed

Друкувати сторінку

Stage 2 Fitting the centre support

Bolt the two adjustable legs onto the central support bar using fixings

provided and drop the assembled unit into the support in the head and

foot of the bed frame. Ensure that the central rail sits square and the

three supporting legs sit vertically. The three adjustable feet should sit

5mm to 10mm away from the floor. DO NOT ADJUST THE FEET TO BE IN

CONTACT WITH THE FLOOR.

Stage 4 Electrical connections

1. Connect the red phono plug (lift

motor connection) from the

footboard to the red phono socket

on the control box. (connection A)

2. Connect the two black phono

plugs (lift buttons) from the two

side rails to the two black phono

sockets on the control box.

(connections B)

3. Connect the TV power lead

supplied in pack 4 between the

transformer and power socket on

the control box (marked mains

output to TV). (connections C & F)

4. Connect the 3m power lead to

the power socket on the control

box and connect to mains power

source. When power is connected

5mm - 10mm

Floor

the control box will emit a beep.

(connection D)

5. The three HDMI cables from the

footboard can be routed to sit in

the DVD compartment ready for

connection to DVD players, games

consoles etc. (connection E)

6. The aerial lead coming from the

footboard should be connected to

the aerial source. Please note the

bed is supplied with a male

antennae connection. For best

signal quality this should be

plugged directly into a female

aerial socket. Use of adaptors will

degrade the quality of the signal.

7. Test the lift function on both side

rail operate buttons.

Stage 3 Fitting the equipment tray

Partially screw the two screws into the fixing holes at either end of the

equipment tray. Drop the tray into position on the side rail and tighten all

the screws at ends of side rails and on equipment tray with the allen key

provided.

Stage 5 Fitting the wooden slats

Assemble each pair

of wooden slats with

the two plastic end

caps and one centre

cap. Push firmly

down on each cap to

ensure they are

snapped into

position in the rails.