Drehmo 384771 Дополнительное руководство по эксплуатации - Страница 4
Просмотреть онлайн или скачать pdf Дополнительное руководство по эксплуатации для Переключатель Drehmo 384771. Drehmo 384771 12 страниц. Simc with limit switching unit
Печатать страницу
1.1 Setting the torque values
The torques are set by manufacturer as instructed according to the order. The torques are
only indicated on the name plate if this is specifically requested. If no torques are specified
on the order, the smallest possible torque is set by the manufacturer. The torque can be
infinitely varied within the range given on the name plate by means of the torque scales
affixed to the unit
Use the setting screws for torque setting if torque signals are to be used (refer to fig-
ure 1.1). Loosen screw on top of the cams if torque setting is to be performed in direction
OPEN. The screw on the bottom of the cams is used for torque setting in direction CLOSE.
After unfastening the respective screw, the cams can be readjusted by turning. Turn the
cam until the desired value on the scale is aligned with the mark. Finally, fasten the
appropriate screw.
4
1. Locking screw for torque adjust-
2. Scale with setting range for torque
3. Setting mark (in this instance
4. Scale with setting range for torque
5. Torque switch for direction OPEN
6. Torque switch for direction CLOSE
7. Locking screw for torque adjust-
Figure 1.1: Torque setting
1. COMMISSIONING
ment OPEN
in direction OPEN
30 Nm for both directions)
in direction CLOSE
in standard version
in standard version
ment CLOSE
Additional operating manual