Drehmo 384771 Additional Operating Manual - Page 4

Browse online or download pdf Additional Operating Manual for Switch Drehmo 384771. Drehmo 384771 12 pages. Simc with limit switching unit

Print Page

1.1 Setting the torque values

The torques are set by manufacturer as instructed according to the order. The torques are

only indicated on the name plate if this is speciﬁcally requested. If no torques are speciﬁed

on the order, the smallest possible torque is set by the manufacturer. The torque can be

inﬁnitely varied within the range given on the name plate by means of the torque scales

aﬃxed to the unit

Use the setting screws for torque setting if torque signals are to be used (refer to ﬁg-

ure 1.1). Loosen screw on top of the cams if torque setting is to be performed in direction

OPEN. The screw on the bottom of the cams is used for torque setting in direction CLOSE.

After unfastening the respective screw, the cams can be readjusted by turning. Turn the

cam until the desired value on the scale is aligned with the mark. Finally, fasten the

appropriate screw.

1. Locking screw for torque adjust-

2. Scale with setting range for torque

3. Setting mark (in this instance

4. Scale with setting range for torque

5. Torque switch for direction OPEN

6. Torque switch for direction CLOSE

7. Locking screw for torque adjust-

Figure 1.1: Torque setting

1. COMMISSIONING

ment OPEN

in direction OPEN

30 Nm for both directions)

in direction CLOSE

in standard version

ment CLOSE

Additional operating manual