AirTech ACR35CV Инструкции по установке и подключению - Страница 7

Просмотреть онлайн или скачать pdf Инструкции по установке и подключению для Вентилятор AirTech ACR35CV. AirTech ACR35CV 13 страниц.

Fan Control Mode

There are 3 modes for fan speed control. Wall, ducted and constant airflow/ volume

(CV) mode (CV - Pro models only). In wall or ducted mode, the fan speeds are pre-

determined at the factory and does not use the airflow sensor.

In CV mode (Constant Airflow/Volume), the fan will automatically adjust the fan speed

to maintain the desired airflow. After the first 15 minutes of operation the fan enters

calibration mode to determine the most efficient mode of operation.

Calibration Reset

In some circumstances it may be necessary to reset the calibration settings (if the fan

was covered to prevent dust/damage/or poor weather outside).

Reset the calibration by configuring the fan for wall or duct mode (F-0 or F-1), turn the

product off and on and re-configure back to CV mode (F-2).

The fan will calibrate after 15 minutes or by holding the pullcord for 5 seconds.

Pullcord

Switches the fan from trickle to boost (for boost overrun time)

o If the overrun time has been set to 0 (disabled), a default overrun duration

of 5 minutes will take place.

This will override LS comfort mode, boosting the fan immediately

An activation when a Pullcord/LS (Light Switch) boost is already active shall cancel

overrun timer (RH boost sources remain unaffected)

Data Logger Menu

* When the display is rotated the decimal point will no longer display; eg. 055 represents

5.5KWh

Display text

tot run 00y 00d

Tri run 00y 00d

Boo run 00d

rhu run 00d

tot EnErgy 00.0

24h EnErgy 00

Cutting the power to the fan will not erase the stored data. To reset the data, hold

pullcord for 14 seconds while in the data logger menu.

Description

Total run time in years and days

Trickle speed run time in years and days

Boosted run time in days

Humidity boosted run time in days

Total Energy used displayed in KWh*

Energy used in last 24 hours displayed in Wh