1Wing XBow2 Инструкции по сборке - Страница 5

Просмотреть онлайн или скачать pdf Инструкции по сборке для Игрушка 1Wing XBow2. 1Wing XBow2 10 страниц.

Tail boom interface

Prior to gluing, please make sure to check if the

tube may penetrate the wing far enough

(>15mm). Rempove excessive material with

Dremel or round file.

Please roughen the tubes surfaces (100-320

sand paper):

8mm Tube: complete outer surface

9mm Tube: complete inner surface and outer

surface, leave 12mm untouched

10mm tube: inner surface

Clean with alcohol

Apply thickened gluing epoxy to the wing

opening. Make sure to put some epoxy to the

radii as well to reinforce the area.

Glue 8mm tube into 9mm tube.

Glue the 10mm tube to the 9mm tube in a way

that 12mm remain for the actual connection to

the tail boom.

Put epoxy to the remaining roughened tube

area as well and slide the tube into the wing

opening. Remove excessive epoxy with alcohol

and Q-tips.

Slide tail boom onto the interface and align e.g.

on tables edge. Make sure the tail boom is

straight in longitudinal direction. Up/down is

not too important since there is no horizontal

stabilizer.

Let all adhesions cure over night.

1Wing

Martin Stobbe

Am Kuchelberg 2

82266 Inning am Ammersee