Electrolux E30WV60PPS Руководство по установке, использованию и уходу - Страница 11

Просмотреть онлайн или скачать pdf Руководство по установке, использованию и уходу для Вентиляционная вытяжка Electrolux E30WV60PPS. Electrolux E30WV60PPS 12 страниц. 30"(76.2 cm) and 36"(91.4 cm) range hood
Также для Electrolux E30WV60PPS: Руководство по установке, использованию и уходу (12 страниц)

Печатать страницу

1. Venting Requirements

Maintenance

ATTENTION! Before performing any maintenance

operation, isolate the hood from the electrical supply

by switching off at the connector and removing the

connector fuse.

Or if the appliance has been connected through a plug

and socket, then the plug must be removed from the

socket.

Cleaning

Do not spray cleaners directly to the control while

cleaning the Hood.The cooker hood should be

cleaned regularly (at least with the same frequency

with which you carry out maintenance of the fat filters)

internally and externally. Clean using the cloth damp-

ened with neutral liquid detergent. Do not use abrasive

products. DO NOT USE ALCOHOL!

WARNING:

Failure to carry out the basic cleaning recommenda-

tions of the cooker hood and replacement of the filters

may cause fire risks.

Therefore, we recommend oserving these instructions.

The manufacturer declines all responsibility for any

damage to the motor or any fire damage linked to

inappropriate maintenance or failure to observe the

above safety recommendations.

Grease Filter

To Remove Metal Grease Filters:

•

Use 2 hands to remove the metal grease filters.

Grasp filter handles, push toward the rear of

the range hood and pull down on the front handle

to remove.

To Reinstall Metal Grease Filters:

•

Grasp filter handles and place rear of filter into

rear track.

•

Push down on the rear handle and set the front of

the grease filter into the front track to secure.

•

Repeat for each filter.

•

Wash metal grease filters as needed in a

dishwasher or hand wash in a hot detergent

solution to clean.

Replacing the light bulb

CAUTION

Before replacing the lamps, switch power off at

service panel and lock service panel disconnecting

means to prevent power from being switched on ac-

cidentally.

NOTE: Turn off the lights and fan. Allow the lights to

cool before handling. If new lights do not operate be

sure lights are inserted correctly before calling service.

Replace Lights

Remove the damaged light (twist counter clockwise)

and replace with a new 120 Volt, 50 Watt (maximum)

50° halogen light made for a GU10 base, suitable for

use in open luminarie.

Maintenance