Atlantic SP1600 Руководство по эксплуатации - Страница 11
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Газонное и садовое оборудование Atlantic SP1600. Atlantic SP1600 16 страниц. Oasis series skimmer, filterfalls, pump vault, fastfalls
Также для Atlantic SP1600: Руководство по эксплуатации (12 страниц)
Печатать страницуOasis Pump Vault Installation
The PV1700 is Atlantic's most compact, easy to install pump vault. The PV1700's features
include an incredibly strong enclosure, recessed panels on the front that can accommodate
Triton 3-Way Diverters, cut lines on the back for 11/2" and 2" pump discharges, and marked
drill points on the left and right sides for an Auto Fill.
EXCAVATING AND SETTING THE PV1700 for a WATERFALL or STREAM
Once you have determined the proper size basin for your project, begin by deciding the
placement of the vault. The vault should be placed away from the waterfall where the lid
can be accessed easily. The PV1700 flat panel will sit flush against the Eco-Blox, so that
water can enter the pump vault. The area where the pump vault will sit should be dug 22"
deep for the PV1700. When using Eco-Blox, the pump vault will recess lower than the
Eco-Blox (Figure A). The area for the Eco-Blox to sit should be dug 18" deep.
Figure A.
Once excavation is complete, install underlayment, pond liner, Eco-Blox and pump vault.
Backfill the space between the Eco-Blox and the excavation to lock them into place, either
outside the liner with sand or clean fill, or inside the liner with gravel ¾" or larger in
diameter. Top the liner and basin with ¾" or larger gravel or decorative stone. Smaller,
more decorative gravel, landscape glass, etc. can be used to cover the top of the basin,
provided a denser mesh is installed beneath the material.
PLUMBING THE PV1700 for a WATERFALL or STREAM
The PV1700 has pump discharge step fittings
molded into each side of the enclosure. The
step fittings are labeled for 1 ½" or 2" PVC pipe
and have cut lines molded in for each size
(Figure B). This allows the installer the flexibility
to exit out the left or right side. The flat panel
on the back is for an overflow. The two drill
points near the top of the left and right sides
are for the installation of an Auto Fill (See Auto
Fill and Overflow instructions on pg. 16).
Figure B.
11