Dri-Eaz Dragon K85 Mobile Руководство пользователя - Страница 4
Просмотреть онлайн или скачать pdf Руководство пользователя для Печь Dri-Eaz Dragon K85 Mobile. Dri-Eaz Dragon K85 Mobile 20 страниц. Dri-eaz dragon k85 mobile furnace owner's manual
Также для Dri-Eaz Dragon K85 Mobile: Руководство пользователя (14 страниц)
Печатать страницуAttaching the flue to the Dragon
The Dragon is designed to operate with the flue attached
to the top of the unit. Always operate the Dragon with the
flue attached. In addition to preventing any water or
debris from falling into the heat exchanger, the flue
creates a slight draft on the Dragon exhaust that assists
in preventing thermal overload.
1. To attach the flue, slide it over the pipe on top of the
heat exchanger.
Attach the flue to the Dragon
2. Drill two 1/8-inch holes through the bottom of the
flue into the heat exchanger pipe. The holes should
be approximately 90 degrees apart.
Drill two 1/8-inch holes in the flue
07-00407 E 08/2006
Copyright 2006 Dri-Eaz Products, Inc.
3. Drive a sheet metal screw (#8x1) through each hole
to secure the flue to the Dragon.
Secure the flue to the Dragon with sheet metal screws
Attaching ducting to the Dragon
The Dragon delivers clean heat to a structure through
two 30-foot lengths of 8-inch diameter aluminum ducting.
You must attach both lengths of ducting to the Dragon
for operation.
1. Extend a 1-foot section of ducting and slide a hose
clamp over the end. Slip the ducting over one of the
Dragon outlet duct rings. Secure the ducting firmly to
the duct ring with the hose clamp. Make sure the
clamp is tight enough to hold the ducting in place
when you extend it to the structure.
Clamp the ducting securely to the duct ring
4