Atlantic Ultraviolet Sanidyne PREMIUM Руководство пользователя - Страница 10
Просмотреть онлайн или скачать pdf Руководство пользователя для Аксессуары Atlantic Ultraviolet Sanidyne PREMIUM. Atlantic Ultraviolet Sanidyne PREMIUM 20 страниц. Germicidal ultraviolet portable area sanitizer
Печатать страницу
Step 4 – Using the lamp, apply
slight pressure to compress the lower
lampholder, and then pivot the lamp so
it aligns with the top lamp socket. Lamp
should appear straight when it is correctly
in place. Confirm pins are inserted and
that both ends align. As shown above,
adjust each lamp socket if there is any gap
between the lamp base and lamp socket.
u
P
nit
laCement
• The Sanidyne
Premium is intended for indoor use only. It should be protected from liquid intrusion such as dripping
®
water, condensation or mist, and used only in a clean, dry location with temperature ranges between 40 °F to 95 °F.
• Electrical power supplied to the Sanidyne
•
The Sanidyne
should this sanitizer be permitted to operate with humans, plants, or animals present in the Operation Area.
• The intrusion sensors will detect movement if anyone is in the treatment area and the lamps will be switched off until fixture is
reset by pressing the START/STOP button on keypad on the top of the Sanidyne
• For maximum efficiency the Sanidyne
treatment area. The Sanidyne
the room and the ultraviolet rays are unobstructed.
UNIT OPERATION
P
-o
re
Peration
1.
Fully charge the Hand-held Remote Controller (Shown in Figure 4). NOTE: Charger provided operates on 100 volt to 240
volts 50/60Hz and has a NEMA 1-15 plug.
2. Once a location has been chosen for the Sanidyne
Premium on all access doors to the area where treatment operation will take place.
It is the users responsibility to post signs, or notices for all personnel and persons in the building or facility
so that they be made aware that the Operation Area is off limits during treatment.
3.
Connect the Sanidyne
listed on the Sanidyne
Approved Promate
worn prior to the next step by the operator as well as anyone else in the operation area. In addition the
operator and anyone present MUST use protective gloves and clothing to protect skin from UV rays.
4.
Turn power on using the Power Switch located on the rear of the Sanidyne
on Figure 2 - Rear View of Unit). Switch will glow RED when power is on. Once fixture receives power, the RED lights
located just below the Occupancy Sensors on the top of the fixture will glow RED. (See Occupancy Sensors (4-Total), shown
on Figure 1 - Dimensional Data). This is not a warning, it indicates that the sensors are aware of your presence.
10
Step 5 – Repeat until all lamps
have been installed.
Premium must match power requirements listed on the Sanidyne
®
Premium is intended for use in UNOCCUPIED AREAS ONLY. Under no circumstances
®
Premium should be located as centrally as possible, away from the corners of the
®
Premium Portable Area Sanitizer is most effective when it is located in the vertical center of
®
Premium to a properly grounded outlet power source which matches the power requirements
®
Premium (See Power In location shown on Figure 2- Rear View of Unit)
®
™
Face Shields (2), are supplied with each unit. Promate
Premium post Laminated Warning Signs supplied with the Sanidyne
®
Premium (See Power Switch location shown
®
Step 6 – Once complete, reinstall
Top Cover.
Premium.
®
™
Face Shield MUST be
Premium.
®
®