Bose AM267565 Руководство пользователя - Страница 18

Просмотреть онлайн или скачать pdf Руководство пользователя для Динамики Bose AM267565. Bose AM267565 34 страницы. Bose corporation user guide speaker am267565

Печатать страницу

Steps to Installing

Figure 17

A 22-inch (55.9 cm) length

of sturdy wire bent in two

places

Figure 18

Checking the space for the

depth of the speaker

Testing the space behind the hole

You need a tape measure and a sturdy wire (such as a straightened coat hanger)

22 inches (55.9 cm) in length for this step.

1. Bend the wire as shown in Figure 17.

3 inches (7.6 cm)

inches

(10.5 cm)

inches

(12 cm)

Tip: For greater accuracy, make the ﬁrst bend a little long, measure again, and cut off the

extra length at that end.

WARNING: If there is a possibility of electrical wiring in the space behind the wallboard, wrap

the wire with electrical tape to prevent electric shock.

2. Make a mark 4

inches (10.5 cm) from the short end as an indicator of the proper front-

to-back depth of the hole.

3. Use the bent wire to test for enough depth, front-to-back:

Insert the short end of the wire into the hole and straight back (Figure 18). Probe to make

sure nothing impedes inserting this end to a depth of 4

that the space behind the wallboard is deep enough for the front-to-back speaker

dimension.

• If the wire goes in without a problem, proceed to step 4, below.

• If you cannot insert the wire to the 4

hole elsewhere. Then repeat step 3.

4. Use the wire again to test the width, side-to-side:

With the short end still in the hole, reposition it (as shown in Figure 19) and rotate it 360˚

around the hole. This indicates if the wall space is wide enough on each side of the hole

for the side-to-side dimension of the speaker.

AM267565_01_V.pdf May 13, 2003

inches

(36.2 cm)

inches (10.5 cm). This indicates

-inch (10.5 cm) mark, you need to drill a new pilot