Bose AM267565 Kullanıcı Kılavuzu - Sayfa 18

Konuşmacılar Bose AM267565 için çevrimiçi göz atın veya pdf Kullanıcı Kılavuzu indirin. Bose AM267565 34 sayfaları. Bose corporation user guide speaker am267565

Sayfayı Yazdır

Steps to Installing

Figure 17

A 22-inch (55.9 cm) length

of sturdy wire bent in two

places

Figure 18

Checking the space for the

depth of the speaker

Testing the space behind the hole

You need a tape measure and a sturdy wire (such as a straightened coat hanger)

22 inches (55.9 cm) in length for this step.

1. Bend the wire as shown in Figure 17.

3 inches (7.6 cm)

inches

(10.5 cm)

inches

(12 cm)

Tip: For greater accuracy, make the ﬁrst bend a little long, measure again, and cut off the

extra length at that end.

WARNING: If there is a possibility of electrical wiring in the space behind the wallboard, wrap

the wire with electrical tape to prevent electric shock.

2. Make a mark 4

inches (10.5 cm) from the short end as an indicator of the proper front-

to-back depth of the hole.

3. Use the bent wire to test for enough depth, front-to-back:

Insert the short end of the wire into the hole and straight back (Figure 18). Probe to make

sure nothing impedes inserting this end to a depth of 4

that the space behind the wallboard is deep enough for the front-to-back speaker

dimension.

• If the wire goes in without a problem, proceed to step 4, below.

• If you cannot insert the wire to the 4

hole elsewhere. Then repeat step 3.

4. Use the wire again to test the width, side-to-side:

With the short end still in the hole, reposition it (as shown in Figure 19) and rotate it 360˚

around the hole. This indicates if the wall space is wide enough on each side of the hole

for the side-to-side dimension of the speaker.

AM267565_01_V.pdf May 13, 2003

inches

(36.2 cm)

inches (10.5 cm). This indicates

-inch (10.5 cm) mark, you need to drill a new pilot