Bose 10.2 Stereo Everywhere Руководство по эксплуатации - Страница 15
Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Акустическая система Bose 10.2 Stereo Everywhere. Bose 10.2 Stereo Everywhere 29 страниц. Commercial sound system
Также для Bose 10.2 Stereo Everywhere: Руководство пользователя (8 страниц)
Печатать страницу®
102
SYSTEM CONTROLLER TEST PROCEDURES
6.5 Both music channels should drop
±
30 dB
3 dB.
Note: The mute release time is 2 seconds.
It may be necessary to repeat procedure
6.4 several times to check the mute
specification on both channels.
6.6 Move the mute switch on channel B to
the OFF position.
6.7 Repeat step 6.4.
6.8 Channel A should drop 30 dB
Channel B should not be affected.
6.9 Return the channel B mute switch to
the ON position.
7. Voice Channel Test
Note: The voice channel input must be
loaded with a 600 ohm input impedance in
order to get the correct output levels.
7.1 Apply a 20 mV rms, 1 kHz signal
to the voice channel input.
7.2 The output should be 20mV rms,
±
(0dB
2dB). Reference a dB meter to the
channel A or B output and proceed.
7.3 Move the voice switch to the MIC
position.
7.4 The output should be 600 mV rms,
±
(+30dB
2 dB).
7.5 Return the Voice Switch to the LINE
position.
7.6 The output should be 20 mV rms,
±
(0 dB
2 dB).
7.7 Turn the Opti-Voice
clockwise. The output should be 600 mV
±
rms, (+ 30 dB
2 dB).
±
3 dB.
®
level fully
15
7.8 Turn the Opti-Voice level control fully
counterclockwise. The output should be
20 mV rms, (0 dB
8. Voice Channel Response Test
8.1 Apply a 300 mV rms, 1 kHz to the
voice channel input. Reference a dB
meter to the channel A and B output.
8.2 Perform the tests listed in the 102
System Controller Voice Channel Re-
sponse table below.
102 System Controller Voice Channel
Response
Frequency (Hz)
1000
80
200
8000
20,000
9. Automatic Gain Control Test
9.1 Apply a 2 Volt rms, 1 kHz signal to
the voice channel input.
9.2 The output level should be
±
900 mV rms,
100 mV.
10. Voice Channel Distortion Test
10.1 Apply a 1 Volt rms, 1 kHz signal
to the voice channel input.
10.2 Measure the distortion at both the
channel A and B outputs. It should be
less than .1 %.
±
2 dB).
Response (dB)
0 Reference
-10 +/- 3dB
+0.5 +/- 2dB
+3 +/- 2dB
-5 +/- 2dB