Drolo Moon Rabbit Phaser Руководство - Страница 3

Просмотреть онлайн или скачать pdf Руководство для Музыкальное оборудование Drolo Moon Rabbit Phaser. Drolo Moon Rabbit Phaser 6 страниц. Phaser

bypass

The pedal uses a relay bypass. If you give the bypass switch a short tap (<0.3 sec) it acts in latching

mode. If you press it for more than 0.3 seconds, the bypass led will start flashing to indicate that you

are in momentary mode. When you release the switch the pedal goes back to bypass mode.

tap tempo

Tap in the desired tempo for the LFO modulation. The LFO will apply twice the rate you tap.

wave shape

Selects one of the 8 available modulation wave shapes for the LFO:

ramp up, ramp down, square, triangle, sine, hypertriangle, random steps, random slopes

env

Allows you to adjust the sensitivity of the envelope follower to the level of the input signal. The

follower converts the input signal into a control voltage that can be used to affect the rate or the

range parameters. Like with an auto-wah, the louder you play the higher the control voltage.

rate

Sets the speed of the modulation. The max speed range will give you ring modulator type sounds.

range

Shifts the range of the modulation between its max and minimum points

The range pot can only be effective if depth is less than maximum.

If depth turned fully down, range can be used as a manual phase shift control.

If you are using the envelope follower to control the range, you can fine tune the sweep with the

range knob to find the sweet spots that sound best.

depth

Sets the depth of the modulation. (the width of the LFO wave)

fdbk

Feedback (regeneration) sets the amount of phased signal that gets reinjected into the phaser for a

more intense resonant effect. At the max setting it makes the phaser oscillate. The volume of the

oscillation is limited by clipping diodes to overdrive more pleasingly and also avoid any

hearing/material damage but watch out anyway :)

mix

Dials in the mix between wet (CW) and dry (CCW) signals