anko HB956SH6PA Руководство по эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Блендер anko HB956SH6PA. anko HB956SH6PA 10 страниц. Hand-held blender

. Make sure the blender shaft, whisk or chopper in place, the power cord is
not damaged before using the appliance every time.
. Never let the blades face towards anybody while operating the appliance.
. Take special care when preparing food for babies, the elderly and infirm.
. Always ensure that the hand blender shaft, whisk or chopper is
thoroughly sterilized by washing it with hot water.
. Never blend or mix hot oil, fat. Please follow the processing guide in the
manual.
. Do not let the power cord hang over edge of the table or counter.
. Never let anybody trip over the power cord.
. Do not let the power cord touch hot surfaces or hang down where a child
could grab and pull on the power cord.
. Unplug from mains power outlet when it is not in use, before moving the
appliance or when adding the food for blending or chopping and before
cleaning.
. Do not use outdoors.
. Blades are sharp. Handle carefully.
. Never touch the blades or whisk while the machine is connected to mains
power.
. Never add ingredients while the hand blender is operating.
·The ingredients used should does not exceed the maximum capacity of
the chopper bowl.
·Do not continuously operate the blender for too long. The motor may
overheat. If the surface of the hand blender becomes very hot, allow it to
cool down to room temperature before using it again.
IMPORTANT! The continuous operating time without the load must
be less than 15 seconds.
·Do not exceed the quantities and maximum time indicated in the
operation guidelines or processing guide.
.Take the attachments off before cleaning.
.The use of attachments not supplied with the product may cause injury.
. Avoid contacting moving parts.
. Keep fingers, hair, clothing and utensils away from moving parts.
IMPORTANT! Keep hands and utensils out of the container which
holds the food while blending or cutting to reduce the risk of severe
injury to persons or damage to the blender.