DryGuy Thermanator DG2 Руководство по эксплуатации - Страница 6

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Сушилка DryGuy Thermanator DG2. DryGuy Thermanator DG2 8 страниц. Silent boot, shoe and glove dryer

Печатать страницу

• Place the DryGuy

brackets to 16" on center (common distance between wall studs) and level contact with the wall.

• Further adjust DryGuy

the wall. Securely tighten the four self locking nuts, making sure not to move saddle clamps out of

alignment.

• With saddle clamps securely tightened, locate wall studs and measure up from the floor to a desired

level, mark the wall where you want to mount the unit, making sure you have found the wall studs

and pre-drill screw holes with the appropriate size drill bit (If wall stud spacing is not appropriate for

proper mounting, insert the suitable size molly bolt for hollow walls following molly bolt manufacturer's

instructions).

• Place clear screw cap cover washer onto screws (See Fig. 3) and securely screw completed DryGuy

Thermanator

assembly into pre-drilled holes in the wall or molly bolts.

™

• When complete and secure, push white finish plastic cap to cover screws.

• Please note-When wall mounting DryGuy

positioned on the left, not on the right (as pictured on package). When mounting DryGuy

in multiple tiers, allow a minimum of 18" between the main horizontal metal tubes.

IN-lINe sWITch INdIcATION:

• Switch can be pressed down from either side, as shown (See Fig. 4). Do not open switch. Keep switch

away from water.

• Press knob down to turn on the DryGuy

Thermanator

against the wall (power cord on left) and adjust the wall-mounting

™

Thermanator

™

dryguy.com

so drying tubes are approximately 11" to 12" away from

™

Thermanator

™

Fig 2

Thermanator

, press knob down to turn off (See Fig. 4).

™

(See Fig. 2) face unit so power cord is

Fig 4

™

Thermanator

™

Fig 3