DSC PC51O2-433NA Руководство по установке - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке для Система безопасности DSC PC51O2-433NA. DSC PC51O2-433NA 13 страниц.

Печатать страницу

The system will generate a General System Supervisory trouble if the module is removed

from the Keybus. If you need to remove the PC5102-433 module from an existing system,

you will have to disable supervision of the PC5102-433.

NOTE

NOTE: Deleting all wireless keys from the PC5102-433 or defaulting the PC5102-433 will

NOTE

cause a supervisory fault.

To disable PC5102-433 supervision:

1. Disconnect the PC5102-433 from the Keybus

2. Enter [✱][8][Installer 's Code].

3. Enter [902]. The control panel will clear all supervision and re-scan the system for

connected modules. The scan will take approximately one minute.

4. To exit press [#].

To review which modules the control panel is currently supervising:

1. Enter [✱][8][Installer's Code]

2. Enter [903] to display all modules. On LED keypads, light [17] will indicate that the

PC5102-433 is present on the system. On LCD keypads, scroll until the module

name PC5132 appears on the display.

3. To exit press [#].

If the PC5102-433 module does not show on the keypad, one of the following conditions

may be present:

• the module is not connected properly to the Keybus

• there is a problem with the Keybus wiring run

• the module does not have enough power

• no keys have been enrolled on the PC5102

NOTE: The PC5102-433 will be supervised and displayed as a PC5132.

4.3

PC5102-433 Software Default

Returning the PC5102-433 programming to factory default settings is a quick way to

remove all the enrolled wireless keys from the system and reset all the programming in

section [804].

NOTE

NOTE: Performing this procedure will not change any programming sections except

NOTE

[804]. Resetting the control panel to factory default settings will not return the PC5102-

433 module to factory default settings.

To restore the PC5102-433 programming to the factory default settings:

1. Enter [✱][8] [Installer's Code].

2. Enter programming section [996].

3. Enter the Installer's Code, followed by [996] again. The programming for the

PC5102-433 will be restored to its factory default settings.

4. To continue programming the unit, exit installer's programming by pressing [#] and

then re-enter installer's programming by entering [✱][8] [Installer's Code].

For instructions on restoring the default programming of the control panel or any other

connected module, see your system Installation Manual.

4.4

Deleting Wireless Keys

To remove a wireless key from the system, follow the guideline for enrolling a wireless key

(see section 3.2). Program the ESN as [000000]. The wireless key will then be removed

from the system.

Now that you have completed all PC5102-433 related programming, you can test and

mount the receiver. See Section 5 for more information.

Section 5: Testing & Mounting

5.1

Test the Reception of Wireless Keys

It is very important to test each wireless key. Following these steps will test the signal strength

between the PC5102-433 and the wireless key.

firealarmresources.com