DSC TL280R Руководство по установке - Страница 6

Просмотреть онлайн или скачать pdf Руководство по установке для Система безопасности DSC TL280R. DSC TL280R 16 страниц. Internet alarm communicator - international
Также для DSC TL280R: Руководства по установке (17 страниц), Руководство по установке (16 страниц)

Печатать страницу

Installing Ethernet Communicator in Panel

hazardous, indoor locations only. This manual shall be used with the installation manual of the

panel which is connected to the Ethernet communicator. All instructions specified within the panel

manual must be observed.

All local rules imposed by local electrical codes shall be observed and respected during installation.

Installing the Ethernet Cable (TL2803G(R) Only)

A Category 5 (CAT 5) Ethernet cable must be run from a source with Internet connectivity to the

communicator module, inside the panel. The communicator end of the cable must be terminated

with an RJ45 plug, which will connect to the communicator's RJ45 jack after the communicator is

installed. All requirements for installation of CAT5 Ethernet cable must be observed for correct

operation of the communicator, including, but not limited to, the following:

HSPA(3G)/Dual Alarm Communicator Installation Manual

• Do NOT strip off cable sheathing more than required for proper termination.

• Do NOT kink/knot cable.

• Do NOT crush cable with cable ties.

• Do NOT untwist CAT5 pairs more than ½ in. (1.2cm).

• Do NOT splice cable.

• Do NOT bend cable at right angles or make any other sharp bends.

NOTE: CAT5 specification requires that any cable bend must have a minimum 2 in. (5 cm) bend

radius. Maximum length of CAT 5 cable is 328 ft. (100 m).

NSTALLING

Installing Communicator with HS2016, HS2032, HS2064, and

HS2128 Panel

1. To assemble supplied mounting bracket, perform the following: (see Figure 1).

a. Remove the 4 white plastic standoffs

from the bag provided with the com-

municator kit.

b. Insert the 4 standoffs through the back

of the mounting bracket, into the holes

at each corner.

c. Place the bracket on a flat, solid sur-

face. Hold the communicator compo-

nent side up and orient the 4 holes on

the communicator with the 4 standoffs

protruding from the bracket. Push the

communicator firmly and evenly onto

the standoffs until it is securely

attached to the mounting bracket.

d. Remove the panel front cover.

e. Remove and discard the circular knockout located

in the top-right section of the panel.

2. Install the Communicator into the panel:

a. Attach one end of the PC-LINK cable to the panel

PC-LINK header on the panel (red wire goes on the

right-hand pin of the panel PCLINK_2 header (see

Figure 3)).

b. Insert the assembled communicator into the panel.

c. Locate the screw hole on the right side wall of the

panel (see Figure 2 (screw)). Line up the assembled

communicator with the right side wall of the panel

and, using the screw provided, secure the mounting

bracket to the panel.

THERNET

Mounting Holes

Communicator

Board

Internet Alarm Communicator Installation Guide

OMMUNICATOR IN

Figure 1: Communicator Mounting Bracket

Stand Off

Mounting

Plate

Figure 2:HS2016/2032/2064/2128 Panel

HS2016/2032/2064/2128

ANEL

Mounting

Holes

Mounting Plate

PC-Link cable connector

GSM Radio

RJ-45

screw