DSC TL280R Руководство по установке - Страница 8

Просмотреть онлайн или скачать pdf Руководство по установке для Система безопасности DSC TL280R. DSC TL280R 16 страниц. Internet alarm communicator - international
Также для DSC TL280R: Руководства по установке (17 страниц), Руководство по установке (16 страниц)

Печатать страницу

Initial Panel Programming

fully communicated to all programmed receivers. If this is the first time the communicator

has been powered up, the module will not be able to initiate communication until it has been

programmed.

NOTE: Initialization may take several minutes to complete. Red and yellow LEDs will flash

together during initialization. Do not continue to next step until the red and yellow LEDs

have stopped flashing. (If only the yellow LED is flashing, there is a communicator trou-

ble). Correct trouble indicated by flashes on yellow LED before continuing. (for trouble-

shooting assistance see Table 6 ).

3. Mount the panel in location.

HS2016/2032/2064/2128 Initial Programming

Please refer to the panel manual section 'Alternate Communicator Set-up' for details.

1. In panel section [377] 'Communication Variables', subsection [002] 'Communication Delays',

sub-subsection [1] 'Communication Delay', program 060 (seconds).

2. In panel section [382] 'Communicator Option 3' set option [5] ON.

3. In panel sections [300] 'Panel/Receiver Communication Paths', subsections [001] to [004],

program the subsection with 02 to 06.

NOTE: Refer to panel manual for additional information.

4. In panel section [350] 'Communication Formats', program the communication format as: CID

(03) or SIA FSK (04).

5. In panel sections [311] - [318] 'Partition Call Directions', program the call direction options for

the system.

6. In panel section [401] 'DLS/SA Options', set toggle option [2] 'User Enable DLS' to ON in

order to perform panel DLS session through Ethernet.

NOTE: Before leaving the premises, the installer should verify all programmed communications

paths. See programming options section [851][901] to send immediate test transmissions.

Communicator Troubles displayed on a HS2016/2032/2064/2128

The communication trouble is the only trouble that will appear on the keypad Liquid Crystal Dis-

play (LCD) when encountered by a communicator installed in a HS2016/2032/2064/2128. For

more information about the trouble on the communicator module refer to the panel event buffer or

by accessing [*][2] to view the individual trouble types.

The communicator has 2 on-board LED indicators: a yellow trouble LED and a red network con-

nection status LED.

Yellow Trouble LED

This yellow LED will flash to indicate a trouble on the unit. The number of flashes indicates the

type of trouble. See the table below for the coded flashes and the conditions which will activate the

trouble status LED.

Table 5: Yellow Trouble Status LED

# of

Flashes

Panel Supervision Trouble

Not Applicable

NITIAL

ANEL

Table 4: Communicator Path Programming

Value

OMMUNICATOR

Trouble

Internet Alarm Communicator Installation Guide

ROGRAMMING

Communication Method

Auto Routing

Ethernet 1

Ethernet 2

LED

TATUS

# of

Flashes

Receiver Supervision Trouble

FTC Trouble

Not Applicable

Trouble