DSC Classic PC1565 Краткое руководство - Страница 9
Просмотреть онлайн или скачать pdf Краткое руководство для Панель управления DSC Classic PC1565. DSC Classic PC1565 18 страниц. Security control panels
Печатать страницуBasic Programming
To toggle options "ON" or "OFF"
press the corresponding number on
the keypad. Press [2] and the dash is
replaced by the number, indicating
the option is now "ON". Press [2]
again and the number is replaced with
a dash, indicating the option is now
"OFF".
Go through each of the options in the
section and determine if the option
should be "ON" or "OFF". Once all
the options are selected correctly,
press the [#] key.
The keypad again displays "Enter
Section" followed by the three dashes.
To exit from engineer mode simply
press the [#] once more and the
keypad will revert to normal mode.
That's all you need to get you started
programming the Classic PC1565
control panel.
For complete details of all program-
ming options, refer to the Installation
Manual.
Programming Using a LED
Keypad:
The Master Code
To program the Master Code, enter
[ ][5][current Master Code][40][new
Master Code]. The Master Code must
be four digits unless otherwise indi-
cated by your installer. Enter digits 0
through 9 only. Press [#] to return to
the Ready state.
26
Basic Programming
Wiring Fire Detectors
The diagram below shows how smoke
detectors should be connected to the
Classic PC1565 control panel.
Always check the manufacturer's
instructions for the detector.
NOTE: Any zone which is pro-
grammed as fire will automatically be
configured as SEOL. Therefore only 1
resistor needs to be installed and the
contact should be normally open.
Wiring Fire Detectors
Wiring
7