DSC Classic PC1565 Manuale rapido - Pagina 9

Sfoglia online o scarica il pdf Manuale rapido per Pannello di controllo DSC Classic PC1565. DSC Classic PC1565 18. Security control panels

Stampa la pagina

Basic Programming

To toggle options "ON" or "OFF"

press the corresponding number on

the keypad. Press [2] and the dash is

replaced by the number, indicating

the option is now "ON". Press [2]

again and the number is replaced with

a dash, indicating the option is now

"OFF".

Go through each of the options in the

section and determine if the option

should be "ON" or "OFF". Once all

the options are selected correctly,

press the [#] key.

The keypad again displays "Enter

Section" followed by the three dashes.

To exit from engineer mode simply

press the [#] once more and the

keypad will revert to normal mode.

That's all you need to get you started

programming the Classic PC1565

control panel.

For complete details of all program-

ming options, refer to the Installation

Manual.

Programming Using a LED

Keypad:

The Master Code

To program the Master Code, enter

[ ][5][current Master Code][40][new

Master Code]. The Master Code must

be four digits unless otherwise indi-

cated by your installer. Enter digits 0

through 9 only. Press [#] to return to

the Ready state.

Basic Programming

Wiring Fire Detectors

The diagram below shows how smoke

detectors should be connected to the

Classic PC1565 control panel.

Always check the manufacturer's

instructions for the detector.

NOTE: Any zone which is pro-

grammed as fire will automatically be

configured as SEOL. Therefore only 1

resistor needs to be installed and the

contact should be normally open.

Wiring Fire Detectors

Wiring