ATS Diesel Performance Aurora Plus - 5000 Руководство по установке - Страница 13

Просмотреть онлайн или скачать pdf Руководство по установке для Автомобильные аксессуары ATS Diesel Performance Aurora Plus - 5000. ATS Diesel Performance Aurora Plus - 5000 18 страниц. Aurora plus - 5000 turbo kit (2003-2007) 5.9l dodge

Печатать страницу

Oil Feed Lines

Drain Tubes

(green)

Figure 3: Line and Drain Tube Routing

16. Connect the Wastegate actuator to the port on the Aurora 5000

compressor housing using the ¼" rubber line and two hose clamps (Figure

2, #15) supplied in the kit. The red dashed line in Figure 3 shows the

correct routing.

17. Install the 90° intermediate pipe (Figure 1, #11) onto the compressor

housing of the Aurora 5000 using the o-ring and smaller v-band clamp

(Figure 1, # 26 and # 20). The o-ring goes between the flange on the

Aurora 5000 and the flange on the 90° pipe.

18. Push the 180° silicone hose onto the 90° pipe and align it with the inlet of

the factory charger. Use a 3.5" T-bolt clamp (Figure 1, #22) and a 4.5" T-

bolt clamp (Figure 1, #21) to secure the hose in place.

Note: Make sure both clamps are tight and seated behind the ribs on the

pip and factory charger inlet. If the clamp is tightened on top of the inlet

or pipe rib, the 180° hose may blow off during driving.

19. Install the 2.75" to 3" reducer hose (Figure 1, #9) on to the outlet of the

factory charger using the original 3.25" T-bolt clamp.

20. (2007 Trucks only) The engine lift mount located on the engine block

behind the alternator will have to be replaced with bracket (Figure 1, #18)

(blue)

Wastegate Line

(red)