Auber Instruments WS Series Руководство по эксплуатации и инструкция - Страница 14

Просмотреть онлайн или скачать pdf Руководство по эксплуатации и инструкция для Контроллер температуры Auber Instruments WS Series. Auber Instruments WS Series 18 страниц. Programmable pid temperature controller with dual probe
Также для Auber Instruments WS Series: Краткое руководство (15 страниц), Краткое руководство (14 страниц), Руководство по эксплуатации и инструкция (18 страниц), Краткое руководство (14 страниц)

SET

3 sec

Press and hold SET key for 4 seconds until the Parameter Window displays "LCK".

Release the SET. The display will show "0". Use "+" and "-" keys to adjust the display to

155 (another pass code) and press SET.

Setting the calibration offset. The parameter window will first show "SC "for a second

and then its value, Use "+" and "-" keys to change the setting. When finished, press the

SET again to confirm the change. For example, if the temperature is 1 ° C too high during

calibration then use "-" to set the value to -1 to offset value.

Setting the output percentage. The parameter window will first show "OUt "for a

second and then its value, Use "+" and "-" keys to change OUt value to your desired limit

value and press SET.

Setting Celsius (C) or Fahrenheit (F). When SET is pressed, the display will show "C-

F" and then its value of either "C" or "F". Press "-" for C or "+" for F.

LC8

155

Figure 8. Code 155 Parameter setup flow chart

SET

oAL

SET

Cool

SET

00t

SET

C-F

SET

250

SET

100

SET