Auber Instruments WS Series Manual de instrucciones - Página 14
Navegue en línea o descargue pdf Manual de instrucciones para Controlador de temperatura Auber Instruments WS Series. Auber Instruments WS Series 18 páginas. Programmable pid temperature controller with dual probe
También para Auber Instruments WS Series: Manual rápido (15 páginas), Manual rápido (14 páginas), Manual de instrucciones (18 páginas), Manual rápido (14 páginas)
Imprimir página
SET
30
3 sec
Press and hold SET key for 4 seconds until the Parameter Window displays "LCK".
Release the SET. The display will show "0". Use "+" and "-" keys to adjust the display to
155 (another pass code) and press SET.
Setting the calibration offset. The parameter window will first show "SC "for a second
and then its value, Use "+" and "-" keys to change the setting. When finished, press the
SET again to confirm the change. For example, if the temperature is 1 ° C too high during
calibration then use "-" to set the value to -1 to offset value.
Setting the output percentage. The parameter window will first show "OUt "for a
second and then its value, Use "+" and "-" keys to change OUt value to your desired limit
value and press SET.
Setting Celsius (C) or Fahrenheit (F). When SET is pressed, the display will show "C-
F" and then its value of either "C" or "F". Press "-" for C or "+" for F.
LC8
155
Figure 8. Code 155 Parameter setup flow chart
SET
sc
SET
al
SET
fa
SET
oAL
SET
hy
SET
Cool
SET
00t
SET
C-F
SET
C8
SET
14
0
SET
250
SET
0
SET
0
SET
3
SET
0
SET
100
SET
F
SET
1
SET