AIRTRONICS Blazer Sport Руководство
Просмотреть онлайн или скачать pdf Руководство для Системы управления AIRTRONICS Blazer Sport. AIRTRONICS Blazer Sport 2 страницы.
Печатать страницуTRANSMITTER BATTERY INSTALLATION
1. Press down on the battery cover and slide
WARNING: Improper installation of transmitter batteries
in the direction of the arrow to remove.
can cause serious damage to your system.
2. Install 8 pieces "AA" size alkaline batteries as
indicated on the battery tray. Make sure to match
the polarity (+ and -) as shown in the battery
compartment or the transmitter will not function.
3. Install the battery cover in place and slide to close.
To Open slide cover
Install Batteries
RECEIVER AND SERVO CONNECTIONS
Your Blazer or Blazer Sport R/C system is equipped
Extend the receiver antenna to the full length. Failure
with a BEC receiver to eliminate the need for a
to do so will cause loss of control. Do not cut or bend the
separate battery receiver pack, but you can use a
receiver antenna.
separate power supply if desired for your particular
Be careful to avoid any metal parts coming in contact
model. The following diagram shows a typical
with the servo connectors as this will affect the
connection for the servos and receiver.
performance. Insulate the connectors with tape or use tie
Note that the receiver antenna should be located at
wraps to avoid contact with metal car chassis.
least 2" (50 mm) away from any servo leads and
Please follow the model manufactures recommendations
switches. In electric cars, we recommend that it be
for the correct installation of your radio system in your
at least 4" (100mm) from the electric motor.
car or boat.
Switch
B
AA Dry Cell Battery Holder
Speed Controller
92621
#2
AIRTRONICS
Throttle Servo
#1
Steering Servo
92621
#2
AIRTRONICS
#1
Contender
Speed Controller
Steering Servo
To Close slide cover
A
B
NP-ADJ
Throttle Trigger Adjustment
50/50 or 70/30
(Forward and Reverse)
To Battery
To Motor
Switch
To Battery
To Motor
Trigger set
Screw
Troubleshooting Guide
If your radio system does not operate properly, please
check the following items:
1. Make sure the batteries are properly installed and
check the polarity (+ and -) again.
2. Check that both the transmitter and receiver power
switches are in the ON position.
3. Check the LED Power Indicators and make certain
that all three are on. If not, replace the batteries.
4. Make sure all the receiver and servo connections
are tight.
5. Make sure that the proper frequency crystals are
installed in the transmitter and receiver.
Steering Reverse Switch
WARNINGS
DO NOT OPERATE YOUR SYSTEM IF SOMEONE
ELSE IS ON YOUR FREQUENCY AT THE SAM
TIME.
YOUR MODEL CAN CAUSE SERIOUS
DAMAGE OR INJURY SO PLEASE USE CAUTION
AND COURTESY AT ALL TIMES.
Throttle Reverse Switch
DO NOT EXPOSE THE RADIO SYSTEM TO WATER OR
EXCESSIVE MOISTURE.
PLEASE WATER PROOF THE RECEIVER AND SERVOS
Throttle Trigger Adjustment
BY PLACING THEM IN PLASTIC BAGS OR A WATER
Trigger Set Screw must be
TIGHT RADIO BOX WHEN OPERATING R/C BOAT MODELS.
loosened before adjusting
IF YOU HAVE LITTLE OR NO EXPERIENCE OPERATING
R/C MODELS< WE STRONGLY RECOMMEND YOU SEEK
THE ASSISTANCE OF EXPERIENCED MODELERS OR
YOUR LOCAL HOBBY SHOP FOR GUIDANCE.
R
INC
1185 Stanford Court, Anaheim, CA. 92805
Tel:(714) 978-1895 Fax:(714) 978-1540
WWW.Airtronics.net
BLAZER
Sport
2 Channel Systems Manual
THE CHOICE OF CHAMPIONS
ST-TRIM
AIRTRONICS
LOW
TM-TRIM
ADVANCED TECHNOLOGY FOR NEW GENERATION
R
FULL