AIRTRONICS Blazer Sport Manuel

Kontrol Sistemleri AIRTRONICS Blazer Sport için çevrimiçi göz atın veya pdf Manuel indirin. AIRTRONICS Blazer Sport 2 sayfaları.

Sayfayı Yazdır

TRANSMITTER BATTERY INSTALLATION

1. Press down on the battery cover and slide

WARNING: Improper installation of transmitter batteries

in the direction of the arrow to remove.

can cause serious damage to your system.

2. Install 8 pieces "AA" size alkaline batteries as

indicated on the battery tray. Make sure to match

the polarity (+ and -) as shown in the battery

compartment or the transmitter will not function.

3. Install the battery cover in place and slide to close.

To Open slide cover

Install Batteries

RECEIVER AND SERVO CONNECTIONS

Your Blazer or Blazer Sport R/C system is equipped

Extend the receiver antenna to the full length. Failure

with a BEC receiver to eliminate the need for a

to do so will cause loss of control. Do not cut or bend the

separate battery receiver pack, but you can use a

receiver antenna.

separate power supply if desired for your particular

Be careful to avoid any metal parts coming in contact

model. The following diagram shows a typical

with the servo connectors as this will affect the

connection for the servos and receiver.

performance. Insulate the connectors with tape or use tie

Note that the receiver antenna should be located at

wraps to avoid contact with metal car chassis.

least 2" (50 mm) away from any servo leads and

Please follow the model manufactures recommendations

switches. In electric cars, we recommend that it be

for the correct installation of your radio system in your

at least 4" (100mm) from the electric motor.

car or boat.

Switch

AA Dry Cell Battery Holder

Speed Controller

92621

AIRTRONICS

Throttle Servo

Steering Servo

92621

AIRTRONICS

Contender

Speed Controller

Steering Servo

To Close slide cover

NP-ADJ

Throttle Trigger Adjustment

50/50 or 70/30

(Forward and Reverse)

To Battery

To Motor

Switch

To Battery

To Motor

Trigger set

Screw

Troubleshooting Guide

If your radio system does not operate properly, please

check the following items:

1. Make sure the batteries are properly installed and

check the polarity (+ and -) again.

2. Check that both the transmitter and receiver power

switches are in the ON position.

3. Check the LED Power Indicators and make certain

that all three are on. If not, replace the batteries.

4. Make sure all the receiver and servo connections

are tight.

5. Make sure that the proper frequency crystals are

installed in the transmitter and receiver.

Steering Reverse Switch

WARNINGS

DO NOT OPERATE YOUR SYSTEM IF SOMEONE

ELSE IS ON YOUR FREQUENCY AT THE SAM

TIME.

YOUR MODEL CAN CAUSE SERIOUS

DAMAGE OR INJURY SO PLEASE USE CAUTION

AND COURTESY AT ALL TIMES.

Throttle Reverse Switch

DO NOT EXPOSE THE RADIO SYSTEM TO WATER OR

EXCESSIVE MOISTURE.

PLEASE WATER PROOF THE RECEIVER AND SERVOS

Throttle Trigger Adjustment

BY PLACING THEM IN PLASTIC BAGS OR A WATER

Trigger Set Screw must be

TIGHT RADIO BOX WHEN OPERATING R/C BOAT MODELS.

loosened before adjusting

IF YOU HAVE LITTLE OR NO EXPERIENCE OPERATING

R/C MODELS< WE STRONGLY RECOMMEND YOU SEEK

THE ASSISTANCE OF EXPERIENCED MODELERS OR

YOUR LOCAL HOBBY SHOP FOR GUIDANCE.

INC

1185 Stanford Court, Anaheim, CA. 92805

Tel:(714) 978-1895 Fax:(714) 978-1540

WWW.Airtronics.net

BLAZER

Sport

2 Channel Systems Manual

THE CHOICE OF CHAMPIONS

ST-TRIM

AIRTRONICS

LOW

TM-TRIM

ADVANCED TECHNOLOGY FOR NEW GENERATION

FULL