Duco DucoBox Silent 0000-4490 Руководство по установке - Страница 10

Просмотреть онлайн или скачать pdf Руководство по установке для Вентилятор Duco DucoBox Silent 0000-4490. Duco DucoBox Silent 0000-4490 16 страниц.

ENGLISH

06.B Installer / User mode

To add components to the network, remove or replace, the system should be put in 'Installer mode'� The LED on each component

indicates the active mode of the component (see table in next section)�

'Installer mode' can be activated by pressing the DucoBox Silent 'INST' button (see drawing in section "04�A Connections & but-

tons" on page 8�) Once the LED on the master unit starts flashing, it means that 'Installer mode' is active� Press 'INST' again to

return to 'User mode' (LED fully on or off)� The system reverts automatically to 'User mode' after 15 minutes of inactivity�

06.C LED indications

06.D Setting type of home

Setting the type of home and number of occupants correctly will provide the ventilation system with a better basis to adjust the

mid-position� There are two types of home: low-rise (e�g� a house) and high-rise (e�g� a flat)� Configuration of this component is

obligatory in the Netherlands. The standard setting for a DucoBox is as a low-rise home for 4 (or more) occupants�

Setting type of home

Ensure that 'Installer Mode' has been activated (via the 'INST' button)�

Press 'LOW' for a low-rise or 'HIGH' for a high-rise home�

The yellow LED (see illustration) will flash in a pattern that indicates the

number of occupants: Once, twice (applies for 3 occupants as well) or 4

times (applies for 4 occupants or more)� Press 'LOW' or 'HIGH' respectively

again until the LED pattern matches the correct number of occupants�

Press the 'INST' button to exit 'Installer mode'�

L2000651 Installation guide for DucoBox Silent (Revision N | 13.07.2020)

RED (blinking slowly)

Not in network

GREEN (blinking slowly)

In network

YELLOW (clignotement rapide)

Transitional phase (please wait)

Component is displayed if changes are being put through via the master�

The system is not working correctly because the DucoBox has not been calibrated� Restart the

DucoBox� Follow the guidelines in '10 essential tips' if the problem recurs continually�

In network, waiting for associated components

YELLOW (on) Initialising (system

WHITE or OFF

Normal

BLUE

ORANGE

RED (blinking rapidly)

Logging in

GREEN (blinking rapidly)

configuration in progress)

HIGH

LOW

INST