Duco DucoBox Silent 0000-4490 Руководство по установке - Страница 12

Просмотреть онлайн или скачать pdf Руководство по установке для Вентилятор Duco DucoBox Silent 0000-4490. Duco DucoBox Silent 0000-4490 16 страниц.

ENGLISH

06.H Tips

• Removing all components from the network (e.g. in the event of problems): Activate 'Installer mode' and long-press 'INST'

until the LED starts flashing red� The DucoBox will reboot (around 15 seconds) and the LED will stop flashing�

• Restore factory settings for the DucoBox and all paired components (AS FROM DucoBox version 18xxxx): Long-press 'INST'

and 'ENTER' if not in 'Installer mode'. The network remains in place�

• Use the Duco Network Tool to read out information from components�

07 Air calibration

The system needs to be configured for it to work correctly� This will ensure its operation is as quiet as possible and energy-efficient�

See under the Tools heading at www�duco�eu for information about determining ventilation flow rates�

07.A Air calibration procedure for DucoBox Silent

The air calibration procedure must be carried out on a calm day (no more than wind force 2: leaves rustling, feel-

ing the wind in one's face)�

Air calibrating the DucoBox Silent

Set all exhaust vents so they match the desired flow rate in accord-

ance with the table below� Proper pre-setting makes for rapid and

correct configuration�

Flow

rate

75m3/h

50m3/h

25m3/h

When using DucoVent Design exhaust vents always leave the outer

ring in place for acoustic effect�

Before activating air calibration mode:

• Close all windows and doors�

• Ensure that all duct openings in the DucoBox are fully closed and that the

DucoBox cover is closed!

• Avoid air leaks in the ventilation ducts�

• Set all window ventilators to the open position

L2000651 Installation guide for DucoBox Silent (Revision N | 13.07.2020)

DucoVent

DucoVent Basic

Design

and other vents

100% open

50% open

25% open

Example

Toilet

Kitchen

Bathroom

Storeroom

open