Anywave SRFC-1+1-N Руководство пользователя - Страница 18

Просмотреть онлайн или скачать pdf Руководство пользователя для Контроллер Anywave SRFC-1+1-N. Anywave SRFC-1+1-N 20 страниц. Switch controller

the PA web interface) so that they do not communicate with the Switch

Controller and local on/off operation is restored to the PA front panel buttons.

3. Manual Switch (Local) – Switch Controller in Local (Manual Mode): This is the

normal Local (Manual) operating condition of the Switch Controller – with Switch

Controller in Local mode and the PAs in Remote mode. TXA is switched on and into the

antenna and TXB switched off and into the load. The user may manually (via the buttons

located on the front of the Switch Controller control which TX is on-air and which TX is

into the load.

Manual Switch Action: The Switch Controller has two front panel buttons, labeled

T1 and T2. When PA A is in Local mode, PA On/Off is controlled by the PA front panel

button. When PA A is in Remote mode, the PA On/Off is controlled by the Switch

Controller T1 button. The same goes for PA B and the Switch Controller T2 button.

Local (Manual) switching between the two TXs is accomplished via the T1 and T2

buttons located on the front panel of the Switch Controller. Some rules apply. The Switch

Controller will only allow one PA to be turned on at a time (both TXs cannot be on at the

same time). For example, if both T1 and T2 are off (unlit), and T1 is pressed on (and lit

up) then TXA is ON and TXB will not turn on, even if the T2 button is then pressed (lit

up). If the user wishes to manually switch to put TXB on-air, then both T1 and T2 must

first be turned off (unlit), then the desired TX button may be selected – i.e. the user may

press the T2 button to switch TXB on and into the antenna.

a. The Manual switching process involves (switching from TXA to TXB) ...

i. Both T1 and T2 buttons must be unlit (un-pressed) in order to switch to

ii. Switch Controller T2 button is pressed (becomes lit)

iii. Switch Controller mutes both TXA and TXB (turns both PAs OFF –

iv. Switch Controller switches coax relay so TXB is into the antenna and

v. Switch Controller then unmutes TXB (turns PA B On) while maintaining

vi. TXB ramps up from 0W to the rated output power of TXB, as may be

b. Settings:

i. Switch Controller set to Local mode.

RF-SWITCH-USR-DOC-V2.0, 1/6/2017

the standby TXB

monitored as LPTV_A_RF = Off and LPTV_B_RF = Off)

TXA is into the load.

TXA off (leaves PA A off) – so LPTV_A_RF = Off and LPTV_B_RF =

Open (On).

monitored by LPTV_B_FWD (power meter reading for TXB output

power).

RF Switch Controller User Manual

Page 18 of 20