Cascade 90FX Инструкция по установке - Страница 7

Просмотреть онлайн или скачать pdf Инструкция по установке для Вилочные погрузчики Cascade 90FX. Cascade 90FX 14 страниц. Swing frame paper roll clamp

Печатать страницу
I
NSTALLATION
6
Install pushbutton switch for
SWING function
A
Mount the pushbutton switch on the ROTATE
function control lever using double-sided
foam tape. Apply heat-shrink tubing over
control lever and switch. Use cable ties as
necessary to secure wiring.
B
With Power Relay – Connect the wiring
harness and cables as shown in B below.
C
Direct connection – Connect the wiring
harness and cables as shown in C below.
IMPORTANT: Pushbutton should be installed
on ROTATE function lever (ITA Standards).
When pushbutton is depressed, control lever
should activate SWING function.
CAUTION: Consult OEM for proper positive
(+) power source connection.
B
ELECTRICAL HOOKUP WITH RELAY (recommended)
Fuse
Truck
Fuse Block
(Unswitched)
Truck
3
Fuse Block
(Switched)
Ground
4
Dropping Resistor
(36-96V systems only)
C
DIRECT CONNECTION
Truck
Fuse Block
(Switched)
Ground
6028021 Rev. 1
Relay
Normally-Open
Pushbutton
2
1
AC0351.ill
Diode
Normally-Closed
Solenoid Cartridge Valve
Normally-Open
Pushbutton
12-96V
Coil
Fuse
AC0235.ill
CONTROL LEVER with PUSHBUTTON SWITCH
Cable Ties
AC0236.ill
Foam Tape
Heat-Shrink Tubing
ROTATE Control Lever
Pushbutton switch on
ROTATE control lever
12-96V
Coil
Fuse
Unswitched
Switched
Ground
Relay
Pushbutton Switch
(for SWING function)
NOTE: Remove
A
tubing around
button as desired
Solenoid
Cable
3N2
Control
Valve
Switch
Cable
Solenoid
Coil
Power Supply
AC0585.ill
Wire Harness
AC0586.ill
5